FS 2002 Z06 Silver CAM Bolt ons 434 whp
05-20-2014, 09:16 AM
#1
Advanced
Thread Starter
Member Since: Feb 2014
Location: Omaha NE
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
FS 2002 Z06 Silver CAM Bolt ons 434 whp
SOLD. Please close thread.
Selling for a down payment on a home. I absolutely LOVE this car and am sad to see it go so soon, but I should have bought a house instead of a car. I drove it back from Houston in March and it drove flawlessly while still maintaining great gas mileage. Car has original motor with 97k miles on it. Comp cam swap from TSP with full bolt ons. The build was done at 93k miles. dynoed @ 434whp. Asking $16,500 FIRM! (Reduced from $21,500). Clean title in hand. Located in Omaha. History report available upon request.
TSP Comp Cam 233/239 @ 113 LSA
.595/.605
Comp valve springs/seals
Titanium retainers
Hardened Chromoly pushrods
Ported high volume oil pump
Upgraded timing chain/gears
Granetelli cold air intake with K&N twin filters
TSP 1 3/4" Long Tube Headers
TSP X-pipe w/High flow cats
Borla axle back stinger exhaust
Lowered 2" on stock bolts
Nitto NT01 315/35/18 Rear Tires
Bridgestone Potenza 255/40/17 fronts
Factory polished z06 rims
Blacked out tail light covers
The exterior is in great shape 8.5/10 with minor paint chips in the front bumper, one scratch on the passenger side door, and one rock chip on the lower passenger side of the windshield.
The interior is flawless! 9.5/10. Looks almost new aside from one crack in the heads up housing which you can't even see unless you look for it. Leather has been very well maintained and the dash is always clean. No tears or damage whatsoever to the seats.
Mechanically and electronically everything works in perfect condition. Never had any problems with the motor or the electronics. The HUD still works bright and clear. AC is ice cold.
Much more information including vehicle history can be found via the link above!
Selling for a down payment on a home. I absolutely LOVE this car and am sad to see it go so soon, but I should have bought a house instead of a car. I drove it back from Houston in March and it drove flawlessly while still maintaining great gas mileage. Car has original motor with 97k miles on it. Comp cam swap from TSP with full bolt ons. The build was done at 93k miles. dynoed @ 434whp. Asking $16,500 FIRM! (Reduced from $21,500). Clean title in hand. Located in Omaha. History report available upon request.
TSP Comp Cam 233/239 @ 113 LSA
.595/.605
Comp valve springs/seals
Titanium retainers
Hardened Chromoly pushrods
Ported high volume oil pump
Upgraded timing chain/gears
Granetelli cold air intake with K&N twin filters
TSP 1 3/4" Long Tube Headers
TSP X-pipe w/High flow cats
Borla axle back stinger exhaust
Lowered 2" on stock bolts
Nitto NT01 315/35/18 Rear Tires
Bridgestone Potenza 255/40/17 fronts
Factory polished z06 rims
Blacked out tail light covers
The exterior is in great shape 8.5/10 with minor paint chips in the front bumper, one scratch on the passenger side door, and one rock chip on the lower passenger side of the windshield.
The interior is flawless! 9.5/10. Looks almost new aside from one crack in the heads up housing which you can't even see unless you look for it. Leather has been very well maintained and the dash is always clean. No tears or damage whatsoever to the seats.
Mechanically and electronically everything works in perfect condition. Never had any problems with the motor or the electronics. The HUD still works bright and clear. AC is ice cold.
Much more information including vehicle history can be found via the link above!
Last edited by Mechanical; 11-09-2014 at 09:42 PM. Reason: Sold
07-03-2014, 08:47 AM
#5
Advanced
Thread Starter
Member Since: Feb 2014
Location: Omaha NE
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
BUMP
Recently performed clutch maintenance and fluid flush.
Replaced rear rotors and all four brake pads along with lines bled and new fluid.
Performed transmission maintenance and fluid flush.
All windows retinted.
Recently performed clutch maintenance and fluid flush.
Replaced rear rotors and all four brake pads along with lines bled and new fluid.
Performed transmission maintenance and fluid flush.
All windows retinted.
07-22-2014, 01:07 PM
#10
Drifting
Pics of the crack in the HUD display and windshield chips please?
You said it's "Mechanically and electronically everything works in perfect condition 9/10".
What's not right that you rate it down from 10/10 mechanically and electrically?
Thank you.
You said it's "Mechanically and electronically everything works in perfect condition 9/10".
What's not right that you rate it down from 10/10 mechanically and electrically?
Thank you.
07-22-2014, 03:25 PM
#11
Advanced
Thread Starter
Member Since: Feb 2014
Location: Omaha NE
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
08-13-2014, 07:08 AM
#16
Advanced
Thread Starter
Member Since: Feb 2014
Location: Omaha NE
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
The HUD functions properly, bright and clear. The emblems have been replaced with the C6 Z06 emblems and I can send pictures of each if you can PM me an email address. Thanks!
