Jason913

any more?

Ret.NavyGTO

02 C5Z 33k miles. Forged AES 390, twin 66's, E-85, RPM level 6 TR6060.

jstrader9896

I just listed my 02 Z06 tonight. Very clean car. Heads cam intake nitrous. Need some rear end attention. (Priced low) more details in post.

Jason913

You have my attention.

Jason913

bump... looks like im going to need something by next week.

chaase

I've been following this and if you want something by next week you are going to need to loosen your criteria a little bit. Good luck with your quest. C5s are fun to drive and you will end up loving whatever you get.

Jason913

At this time, it's definitely a buyers market for the c5 and c6. Not really looking to settle, looking for a "forever" car. It has been challenging this far though... lots of people that start talking to me about their car... then disappear when they realize I am serious. The first time I was looking.. i gave up. I am more determined this time! Thanks for the kind words

Black interior, mostly stock exterior... and some go fast parts. Sounds simple to me

chaase

I am not trying to get you to buy something you don't want but just some statistics to think about. You have manual and coupe only in your post. For 2003, 51% of all Corvettes are ruled out because of automatic trans and convertibles make up 40% of production. That brings you down to about 20% of all corvettes made.

Go fast parts are only going to be on a small percentage of the left over 20%. I would say no more 5%. Interior color limits your choice even further.

I would say you are looking for what is probably, at most, 1% of the Corvettes out in the world so it will be a tough road.

Jason913

No I hear you for sure!! Most are definitely autos / verts / bone stock or very close.

Here on the forum is where I can find more manual cars that have been modded a little by enthusiasts. That's why I am here .

The two cars I have seen on here that fit my criteria were sold in two days.!!

chaase

That is not surprising. They are rare apples. If you are in the Northeast you have the benefit of a lot of Corvette owners. Especially where I live on Long Island. Corvettes are ubiquitous here.

Jason913

There is a large amount sitting in garages here in Florida... they are never driven and never sold. Kind of strange

DANZGLASS

my car will be avalable but not till its done which will be a little while yet. But c5z built 5.3 afr top end,built tr6060,built b6z diff, act twin, coil overs, upp fuel kit with some upgrades, wide body, weld rts wheels with 345 mts, custom rear mount single turbo kit. makes 900whp can do more. But not going to be done till summer sometime.

Ret.NavyGTO

PM's responded to.

BobbyO01

Jason913

Bump. Looking to book a flight for fri or sat morning...

Jason913

Bump. My car is officially sold.... so looking for something asap. 2-3 more weeks of this, then going to give up again lol.

Jason913

Bump. Have my eye on one car at the moment.... are there any others lurking?
bump

Choose1

Sent you a PM....

Jason913

Yeah but it's a vert.

Thanks

CuZ06

2002 z06, Quicksilver, 22k miles. 2 owner.
AFR heads 205mm(refreshed by VA motorsports)(All new timing chain set and associated parts replaced when top end was installed
160 degree thermostat
Custom spec comp cam,
Fast 90(Ported by Vengence) intake with matching LS2 TB(ported as well)
ARH 1 3/4" headers with matching X-pipe(catted) with Corsa 4" Extremes
Halltech Intake
c6z06 brakes all way around
18x10.5 c5z06 rear square set-up to clear brakes.
3.90 gears with c6z06 diff internals(Built by RKT-Rick Kim)
Mantic Stage one clutch
LG GT2 coilovers(Aligned and corner balanced by IMA motorsports)
LG G1 Swaybars with LG HD Quiet End links
Corbeau a4 seats
Callaway STS
RadioFlyer Bi-xenon HID
RadioFlyer HID fog set-up
Ford 40lb injectors
Elite motorsports Tunnel plate(with Thermal ABS)
Elite motorsports frame rails
Elite motorsports dead pedal and matching heal/toe gas pedal
Car was tuned by Ed Hutchings and made 459rwhp with plenty of left on the tab

All mods have 10-12k on them or less.

I am asking 29k/obo for the car....it's all done/sorted and ready to roll.

I am sure I am missing some things, feel free to PM me with any questions.

Jason