CHEAP 01 z06
#1
CHEAP 01 z06
Here is the deal. I am trying to get the ball rolling on another vehicle and I need this gone asap before I can do it. Bought this car in Michigan from a dealership factory bone stock March 2014 with 52k on it. The car now has right at 60,500 miles. Mods as listed:
-Pat G custom grind cam 629/629 234/238 112+4
-The normal Brian tooley valve train
-Black fast 92mm intake
-ls2 throttle body with harness
-K&n cold air intake
-Obx 1 7/8 longtubes
-Obx off road x pipe
-B&B Bullets (quad 4")
-Spec 3 clutch about 1000 miles ago
-new gm slave cyl and throw out bearing
-new trans and rear end fluid
-Tick speed bleeder
-Nitrous outlet 92mm plate kit
-Nos window/wot switch
-Nitrous outlet switch panel
-Full nitrous outlet 10lb bottle
-dual billet bottle bracket
-All factory 17" wheels powdercoated black
-295/45/17 Mickey Thompson et streets
The bad:
-needs a speed sensor
-2nd synchro is going bad. Car still goes in gear with no grinds, even at wot. Just doesn't like to downshift.
-pcv was routed wrong for a second and caused a little oil to be sucked into the intake so I would suggest new plugs and o2 sensors and clean up the intake which I could do if someone showed serious intrest.
I drive the car when it's nice, so mileage may change a little. I would have no problem driving the car anywhere. Just drove it to pigeon forge tn for rod run.
The car has NEVER been sprayed. It has never even had jets in the plate. I haven't had the time to hook up the iat switch to pull timing and I didn't want to pull timing away from the motor tune. The car was tuned by dyno tune motorsports in Galloway Ohio. On street tires it made 428/400. On the mickeys it made 424/395.
I'm not real great on computers so I will post my number for serious buyers. If I am not allowed to do this admins please notify me and I will remove it. 740-253-9234
Location is Chillicothe Ohio
Price is 16,000 firm
Will not ship
-Pat G custom grind cam 629/629 234/238 112+4
-The normal Brian tooley valve train
-Black fast 92mm intake
-ls2 throttle body with harness
-K&n cold air intake
-Obx 1 7/8 longtubes
-Obx off road x pipe
-B&B Bullets (quad 4")
-Spec 3 clutch about 1000 miles ago
-new gm slave cyl and throw out bearing
-new trans and rear end fluid
-Tick speed bleeder
-Nitrous outlet 92mm plate kit
-Nos window/wot switch
-Nitrous outlet switch panel
-Full nitrous outlet 10lb bottle
-dual billet bottle bracket
-All factory 17" wheels powdercoated black
-295/45/17 Mickey Thompson et streets
The bad:
-needs a speed sensor
-2nd synchro is going bad. Car still goes in gear with no grinds, even at wot. Just doesn't like to downshift.
-pcv was routed wrong for a second and caused a little oil to be sucked into the intake so I would suggest new plugs and o2 sensors and clean up the intake which I could do if someone showed serious intrest.
I drive the car when it's nice, so mileage may change a little. I would have no problem driving the car anywhere. Just drove it to pigeon forge tn for rod run.
The car has NEVER been sprayed. It has never even had jets in the plate. I haven't had the time to hook up the iat switch to pull timing and I didn't want to pull timing away from the motor tune. The car was tuned by dyno tune motorsports in Galloway Ohio. On street tires it made 428/400. On the mickeys it made 424/395.
I'm not real great on computers so I will post my number for serious buyers. If I am not allowed to do this admins please notify me and I will remove it. 740-253-9234
Location is Chillicothe Ohio
Price is 16,000 firm
Will not ship
#4
It will throw a cel for the speed sensor every now and again. The is very slight play in the steering wheel. Besides that those are the only problems. Interior is beautiful. Exterior has very minor chips I would give it a 8.5/10