2002 Electron Blue Z06 17k Oklahoma
#1
Safety Car
Thread Starter
Member Since: Nov 2012
Location: Enid Ok
Posts: 3,842
Likes: 0
Received 5 Likes
on
5 Posts
St. Jude Donor '13-'14
2002 Electron Blue Z06 17k Oklahoma
2002 Corvette Z06
Clear Title
Vehicle Info:
Mileage: 93k
VIN: PM for VIN
Motor/ECU:
Halltech TRAP Cold Air
Billy Boat Short Headers
Stock H-pipe and Titanium mufflers
Lingenfelter fuel pump
Brian Tooley .660" Lift Platinum Spring Kit with Tool Steel Retainers (@75K, 11/2012)
Brian Tooley LS Chromoly Pushrods 7.400" long (@75K, 11/2012)
Drivetrain/Brake Mods:
Kirban short shifter
Delrin Shift ****
Extended bleeder for clutch slave cylinder
DTE differential brace
TPSMotorsports Slotted Rotors(front and rear)
Suspension Mods:
2001 OEM forged Z06 wheels
Steel braided brake lines
ATE Superblue brake fluid
Carbotech high temp brake pads
Lowered 3/8" on stock bolts
Corner balance alignment
Interior Mods:
Installed Vette Nuts Insulation Kit
TSTAR LED modified HVAC and Rear View mirror
Double D Mods Clarion DVD navigation system with backup Camera
Leather covered door pulls emergency brake cover, steering wheel is covered but showing wear
Z06Parts cabin partition w/ interior matching oem vinyl & carpet
Exterior Mods
Switchback Leds
Halo tailights
adjure rear housing with cree led backup lights
Repairs:
Gas Cap (10/2012)
Steering column lock by-pass
Replaced drivers window regulator
Rebuilt calipers(front and rear)
A/C compressor, drier, and orifice tube
OEM LS7 clutch kit
NGK TR6 plugs
NT05 rear tires near new, has been patched.
New AGM battery
Driver's seat regulator
Transmission rebuilt 6/2008 @ 58K miles w/
1-2 synchro/slider and billet keys
3-4 steel shift fork
3-4 billet keys
McLoed adjustable master cylinder
O2 sensors replaced 4/2007
Rear differential replaced w/ new OEM unit 2/2005 @ 32K miles
Lingenfelter differential hardened output shaft driver side
Lingenfelter trans-axle hardened output shaft
Car was backed into causing damage to front bumper headlight hood and fender.
Parts replaced with OEM parts at local dealership.
Rear bumper has a couple spots showing wear on paint.
Have quite a few spare parts 2 extra steering wheels, door pulls extra console lid covers and a extra console lid including 3 piece Service Manual.
Clear Title
Vehicle Info:
Mileage: 93k
VIN: PM for VIN
Motor/ECU:
Halltech TRAP Cold Air
Billy Boat Short Headers
Stock H-pipe and Titanium mufflers
Lingenfelter fuel pump
Brian Tooley .660" Lift Platinum Spring Kit with Tool Steel Retainers (@75K, 11/2012)
Brian Tooley LS Chromoly Pushrods 7.400" long (@75K, 11/2012)
Drivetrain/Brake Mods:
Kirban short shifter
Delrin Shift ****
Extended bleeder for clutch slave cylinder
DTE differential brace
TPSMotorsports Slotted Rotors(front and rear)
Suspension Mods:
2001 OEM forged Z06 wheels
Steel braided brake lines
ATE Superblue brake fluid
Carbotech high temp brake pads
Lowered 3/8" on stock bolts
Corner balance alignment
Interior Mods:
Installed Vette Nuts Insulation Kit
TSTAR LED modified HVAC and Rear View mirror
Double D Mods Clarion DVD navigation system with backup Camera
Leather covered door pulls emergency brake cover, steering wheel is covered but showing wear
Z06Parts cabin partition w/ interior matching oem vinyl & carpet
Exterior Mods
Switchback Leds
Halo tailights
adjure rear housing with cree led backup lights
Repairs:
Gas Cap (10/2012)
Steering column lock by-pass
Replaced drivers window regulator
Rebuilt calipers(front and rear)
A/C compressor, drier, and orifice tube
OEM LS7 clutch kit
NGK TR6 plugs
NT05 rear tires near new, has been patched.
New AGM battery
Driver's seat regulator
Transmission rebuilt 6/2008 @ 58K miles w/
1-2 synchro/slider and billet keys
3-4 steel shift fork
3-4 billet keys
McLoed adjustable master cylinder
O2 sensors replaced 4/2007
Rear differential replaced w/ new OEM unit 2/2005 @ 32K miles
Lingenfelter differential hardened output shaft driver side
Lingenfelter trans-axle hardened output shaft
Car was backed into causing damage to front bumper headlight hood and fender.
Parts replaced with OEM parts at local dealership.
Rear bumper has a couple spots showing wear on paint.
Have quite a few spare parts 2 extra steering wheels, door pulls extra console lid covers and a extra console lid including 3 piece Service Manual.
Last edited by OKZ06; 08-01-2016 at 06:42 PM.
#3
Drifting
Member Since: May 2001
Location: Edmond Oklahoma
Posts: 1,294
Likes: 0
Received 0 Likes
on
0 Posts
#9
yea its tough out there. was it tuned? did you do the mods or previous owner? 0 mechanical issues?
rear bumper has a couple spots showing wear on paint----that's the only thing wrong with the car?
rear bumper has a couple spots showing wear on paint----that's the only thing wrong with the car?
Last edited by heybro; 08-10-2016 at 03:02 AM.
#11
Safety Car
Thread Starter
Member Since: Nov 2012
Location: Enid Ok
Posts: 3,842
Likes: 0
Received 5 Likes
on
5 Posts
St. Jude Donor '13-'14
Car has some wear on interior with age and wheel coating gone in some areas, and occasionally gets a code for emissions leak.
Drivers door has some scrapes to the edge of the door from opening into something.
Blended to the doors.