1999 FRC ERL 427, TTIX, TR6060, widebooty, welds
#24
Le Mans Master
Is this a superdeck 6 bolt conversion also?
Free bump, the parts list on this one justifies the love.
Great build, if I didn't have one almost as nice, it would be where that one is now.
GLWS
Free bump, the parts list on this one justifies the love.
Great build, if I didn't have one almost as nice, it would be where that one is now.
GLWS
#25
Melting Slicks
Thread Starter
thanks bud, it is not a super deck. It their m1 build. Sleeved ls2 block and 6 bolt heads.
The following users liked this post:
blackcoupe04 (03-30-2017)
#27
Melting Slicks
Thread Starter
after a long winter, shes back out and running great. went to a couple car meets yesterday.
car goes friday for vinyl wrap, going to change the look up a bit. still interested in selling it but like i stated. im going to continue enjoying the car till it does.
car goes friday for vinyl wrap, going to change the look up a bit. still interested in selling it but like i stated. im going to continue enjoying the car till it does.
#28
Melting Slicks
Thread Starter
bump it up. car is almost done getting wrapped. here are a few pictures. car is still forsale but like i stated, im going to continue enjoying it until it does sell.
it should be done today or tomorrow. the color is matte white with blue pearl. i had all the jambs done, and all the inside trunk area and the inside engine bay area. you can not see any red with the car.
i also have c7 carbon ground affects and a front splitter on the way.
a couple other things i did was replace the driver side door, the old door the clear was peeling. i bought a entire door replacement, i also replaced both door glass and got some fresh tint. new glass is absolutely perfect with no scratches. the new door was perfect as well. i also purchased a new set of door speakers to replace to old ones. also replaced the rear glass weatherstrip and also the side glass weather striping.
at this point im trying to take care of all the "flaws" with the exterior of the car. im still asking for the same price for the car. car is running great and now is looking the part to. while the paint wasn't terrible it wasn't great. i also really wanted white. just remember if you dont like it its vinyl and can be removed and i also have a ton of pictures of the paint that is under it so there are no surprises.
it should be done today or tomorrow. the color is matte white with blue pearl. i had all the jambs done, and all the inside trunk area and the inside engine bay area. you can not see any red with the car.
i also have c7 carbon ground affects and a front splitter on the way.
a couple other things i did was replace the driver side door, the old door the clear was peeling. i bought a entire door replacement, i also replaced both door glass and got some fresh tint. new glass is absolutely perfect with no scratches. the new door was perfect as well. i also purchased a new set of door speakers to replace to old ones. also replaced the rear glass weatherstrip and also the side glass weather striping.
at this point im trying to take care of all the "flaws" with the exterior of the car. im still asking for the same price for the car. car is running great and now is looking the part to. while the paint wasn't terrible it wasn't great. i also really wanted white. just remember if you dont like it its vinyl and can be removed and i also have a ton of pictures of the paint that is under it so there are no surprises.
Last edited by StealthFRC; 05-01-2017 at 09:08 AM.
#34
Melting Slicks
Thread Starter
fixed a few of of the small issues with the car and figured out what was causing the oil near the bellhousing. car should be good to go.
belt squeal is also fixed
belt squeal is also fixed
#36
Melting Slicks
Thread Starter
#39