all4spl

I have a ysi and am trying to find a place to mount my tail 38mm wastage. I have 2x trial BOV's welded to top of intercooler and was going to weld watergate flange to where the original A&A blow off valve goes but it is VERY close to brake duct. Wanted to see other ideas.

Smoove

We have one on the F1 X car. Charge pipe comes out of the blower towards drivers side, makes it's first turn(to go towards intercooler),....and that is where we have it. Just before intercooler.

all4spl

Do you happen to have a picture.

Smoove

sure.

Smoove

(it is currently aimed down)

all4spl

thanks ya thats a little different than the A&A setup.

stevieturbo

38mm gate isnt going to bleed much

all4spl

I'll have to test this out but you may be right.

Smoove

I ended up going with a large WG....but I see everyone running smaller ones. So I may be overkill....I dunno, it's all new to me. Typically on a turbo,...larger gates, better control(hot side science).

C5Natie

I have a ysi with a 50mm bov. Mine is just in front of the passenger side wheel well. I put a trumpet on it that blows out into the wheel well and its pretty dang loud lol.

ITSQUIK

Mine is set up the same but with a Ti blower. That 50mm bov with the trumpet is hilariously loud!! LMAO!!