Like new... Harlan Sharp 1.7 rockers
#1
Pro
Thread Starter
Member Since: Apr 2006
Location: New Bern NC
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
Like new... Harlan Sharp 1.7 rockers
These were used for one Dyno pull and wont work with my setup (my cam's ramp is too much) so they had to be taken off. They have been touched up and ready to install with no worries about hitting the heads.
$300 shipped
$300 shipped
Last edited by LETHL_C6; 01-23-2007 at 06:34 PM.
#5
Pro
Thread Starter
Member Since: Apr 2006
Location: New Bern NC
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
Your PM box is full but the touched up part is:
There are a couple of spots on the back side of the rocker that would touch the heads. I took a sanding wheel on a dremel and touched it up slightly to where it wouldnt hit (normally all the center ones are fine but have to watch out for the outer edge on cyls 1,2,7,&8). There is one rocker (intake valve on cyl#5) I sanded a tad on the nose to clear a spot on the drivers side valve cover where a bolt that mounts the coil packs protrudes down.... touched up both the rocker and the valve cover.
There are a couple of spots on the back side of the rocker that would touch the heads. I took a sanding wheel on a dremel and touched it up slightly to where it wouldnt hit (normally all the center ones are fine but have to watch out for the outer edge on cyls 1,2,7,&8). There is one rocker (intake valve on cyl#5) I sanded a tad on the nose to clear a spot on the drivers side valve cover where a bolt that mounts the coil packs protrudes down.... touched up both the rocker and the valve cover.
#8
Race Director
You need to fill out your user profile more.......see the rules below
http://forums.corvetteforum.com/show....php?t=1324902
http://forums.corvetteforum.com/show....php?t=1324902