FS: crane 1.8 shaft mount rockers and 3/8" pushrods
#1
Melting Slicks
Thread Starter
Member Since: Jul 2004
Location: orlando florida
Posts: 3,092
Received 114 Likes
on
98 Posts
St. Jude Donor '15
FS: crane 1.8 shaft mount rockers and 3/8" pushrods
been sitting around for the last few years after i took them off my 408 motor. there are no bearings in this design. they are a polymatrix bearing. rockers were mikronite finished. i drove my car everyday with them installed. pushrods are 3/8" diameter and 7.250" long. you may need longer/shorter, but will come with the rockers anyway.
they were $1200.00 new. $600.00 shipped to 48 states.
instruction sheet
http://www.cranecams.com/uploads/instructions/563e_.pdf
they were $1200.00 new. $600.00 shipped to 48 states.
instruction sheet
http://www.cranecams.com/uploads/instructions/563e_.pdf
Last edited by mrr23; 09-21-2014 at 04:29 PM.
The following users liked this post:
mrr23 (09-10-2015)
The following users liked this post:
mrr23 (09-11-2015)
The following users liked this post:
mrr23 (01-04-2016)
#19
Veteran
I have a friend that just bought an old Datsun 280z with a LS1 swap in it, I will find out if he is interested for you. He was asking the inherent ls1 problems and I remembered u had these after I had already done the trunion upgrade.
The following users liked this post:
mrr23 (01-05-2016)