hobby0002000

Any body looking to sell a set of ported heads.

0tom01ss

what casting are you looking for i keep a could sets on hand at my shop

hobby0002000

Prefer a chamber less than 64cc

ZZOOM06

I have a set of 243's that were CNC ported, angle milled and hand finished by Pete Incaudo of VMax motorsports. They have REV valves, 2.08" intakes/1.60" exhausts with Crane 832 dual springs/ titanium retainers. Chambers are 59cc and with stock MLS gaskets SCR was 11.5 to 1. I am open to reasonable offer but will not give these away as I have right at $1600 in them.

Jimbo

hobby0002000

Thanks, prefer a smaller intake valve then a 2.08.

Still looking.