FS: BRAND NEW 3" QTP Cutouts/Turndowns
#1
Pro
Thread Starter
FS: BRAND NEW 3" QTP Cutouts/Turndowns
SOLD.
Since Maryland Speed shipped by order even after requesting to cancel, I got stuck with their 25% restocking fee (almost $100!). Since I decided not to use them, I'd rather help someone out by giving a forum member a discount on them.
Like stated, these are brand new QTP 3" electric cutouts with their optional turndowns. $390 from Maryland Speed. I pulled the cutouts and one of the turndowns from their respective boxes for the pictures. In addition, I verified that the cutouts work with a 9V battery.
I'll do $350 shipped to the 48 states.
Since Maryland Speed shipped by order even after requesting to cancel, I got stuck with their 25% restocking fee (almost $100!). Since I decided not to use them, I'd rather help someone out by giving a forum member a discount on them.
Like stated, these are brand new QTP 3" electric cutouts with their optional turndowns. $390 from Maryland Speed. I pulled the cutouts and one of the turndowns from their respective boxes for the pictures. In addition, I verified that the cutouts work with a 9V battery.
I'll do $350 shipped to the 48 states.
Last edited by C5Conrad; 11-06-2015 at 02:03 PM.
#3
Pro
Thread Starter
That was my situation. Had B&B Bullets with headers and x-pipe with no cats, so picked up a Ti catback. Was going to put these on, but now I'm thinking of selling the car for a CTS V2.
#4
Safety Car
want these but I'm kinda sittin on the fence about them.... have TIs with the bypass mod, but would like the cut outs for the track...not much $$ left though after the last round of repairs...
#11
Racer
Cut Outs
OK $340.00 shipped to 90808 including p/p fee. E-Mail p/p invoice. "WAIT" I need to confirm 3" will fit in the morning will know by 9am. OK every thing is good.
Last edited by redbob; 10-15-2015 at 05:25 PM.
#19
Melting Slicks
Where are they usually installed? I'm about to install LG Super Pro headers and have Corsa Indy mufflers. The LG X-pipe tapers down to 2.5" right at the connector for the tail section. So 3" wouldn't work past that I assume. Turndowns on the back of the X-pipe may very well scrape. Not sure. Curious.
#20
Pro
Thread Starter
Here you go guys, watch this video by QTP. I was going to let the exhaust shop determine if they were going to use the turndowns for the connection to the X-pipe.
Last edited by C5Conrad; 10-25-2015 at 04:22 PM.