WTB: LH Mirror Jack Screws
#1
Burning Brakes
Thread Starter
WTB: LH Mirror Jack Screws
They're the ones that connect from the electric motor to the back plate of the mirror. I somehow lost one when I went to replace the mirror. The dealer doesn't sell them individually and I don't need to replace the whole LH mirror assembly
Here's a picture of them connected to the mirror backplate
http://97vette.com/howto/mirror/fixed.jpg
Thanks
PM or six2sackmonster@aol.com
Here's a picture of them connected to the mirror backplate
http://97vette.com/howto/mirror/fixed.jpg
Thanks
PM or six2sackmonster@aol.com
Last edited by RBS_Z51C5; 06-14-2016 at 08:39 AM.
#2
Burning Brakes
Thread Starter
they're the ones that connect from the electric motor to the back plate of the mirror. I somehow lost one when i went to replace the mirror. The dealer doesn't sell them individually and i don't need to replace the whole lh mirror assembly
thanks
pm or six2sackmonster@aol.com
thanks
pm or six2sackmonster@aol.com
The following users liked this post:
RBS_Z51C5 (06-13-2016)
#5
Burning Brakes
Thread Starter
The Jack Screws actually connect off of the motor drive just above(northwest)where you're pointing to and higher up on the mirror motor too. They're about half an inch long and have what looks like a small spring in them. Do you remember them connected o the back plate of your broken mirror. On 97vette.com there is a picture of them on the DIY repair of a floppy side mirror. Here's a pic on the link below.
Last edited by RBS_Z51C5; 06-14-2016 at 08:34 AM.
#8
Melting Slicks
Member Since: Nov 2005
Location: Green Valley Arizona
Posts: 3,186
Likes: 0
Received 106 Likes
on
71 Posts
There are only two of these "couplers" per side, not four.
I went through this same problem after purchasing my car and found out that the driver's mirror did not move when the buttons were pressed....both "couplers" were missing. Took me over a month to find them. Try salvage yards for a damaged mirror, either side as they are interchangeable between sides.
Good luck.
I went through this same problem after purchasing my car and found out that the driver's mirror did not move when the buttons were pressed....both "couplers" were missing. Took me over a month to find them. Try salvage yards for a damaged mirror, either side as they are interchangeable between sides.
Good luck.