aem wideband install w/o aem guage
#1
Intermediate
Thread Starter
aem wideband install w/o aem guage
the aem harness has the following wires:
red, switched +12v
black, ground
blue, serial tx
white, analog +
brown, analog -
My a/f gauge has the following wires:
red, ignition switch 12v+
yellow, ignition switch 12v+
green, 02 sensor signal wire to pcm
black, ground
Any information as to how i should wire this would be greatly appreciated!
red, switched +12v
black, ground
blue, serial tx
white, analog +
brown, analog -
My a/f gauge has the following wires:
red, ignition switch 12v+
yellow, ignition switch 12v+
green, 02 sensor signal wire to pcm
black, ground
Any information as to how i should wire this would be greatly appreciated!
Last edited by ecook48; 10-11-2020 at 12:57 PM.