kuzmfly1

Hello after almost being run off highway I ran onto the shoulder and hit the wake up dummy grooves and my abs/ traction control lights came on. I treid to reset the code 1214 and it would not reset. About 7 months ago I did abs fixer diy from forum all was good until this happen any suggestions before I take it apart again. Thanks

chaase

Double check the grounds first, otherwise open her back up.

Trash

The bumps may have jarred some of the solder joints in the ABS box. May have to open it up and look at them again.

Chicago1

kuzmfly1

Thanks for replies opened it up and resolderd 5 points had two of the i geuss there called valve tube where loose pushed back in. put back in and now i'm getting codes 1272 and 1274