[Z06] What did you do to your Z06 TODAY??
#2024
Instructor
Wrap
Cars at Paradise Graphix in Germantown Ohio getting a full wrap.
These guys are amazing and highly recommend
Heading to Pigeon Forge TN Grand Rod Run Thursday
These guys are amazing and highly recommend
Heading to Pigeon Forge TN Grand Rod Run Thursday
#2025
Race Director
Member Since: Mar 2006
Location: Everywhere and Nowhere at all
Posts: 15,357
Received 1,679 Likes
on
1,135 Posts
#2026
#2032
Race Director
Member Since: Mar 2006
Location: Everywhere and Nowhere at all
Posts: 15,357
Received 1,679 Likes
on
1,135 Posts
you go Maxx......
I drove the tires off of mine last night....
I drove the tires off of mine last night....
#2034
Tech Contributor
#2035
!!
I lubed the hinges, cleaned the gasket and put wax on the underside of my trunk lid to try and get it to pop up better. No luck, no change.
But then I took 'er out for a high speed romp on the interstate finished off with a blast over a local mountain pass as I came pack home to my high mountain valley. Such a blast to drive!!
But then I took 'er out for a high speed romp on the interstate finished off with a blast over a local mountain pass as I came pack home to my high mountain valley. Such a blast to drive!!
#2036
Safety Car
Member Since: Sep 2007
Location: Sunniest city on Earth
Posts: 4,169
Likes: 0
Received 21 Likes
on
20 Posts
I lubed the hinges, cleaned the gasket and put wax on the underside of my trunk lid to try and get it to pop up better. No luck, no change.
But then I took 'er out for a high speed romp on the interstate finished off with a blast over a local mountain pass as I came pack home to my high mountain valley. Such a blast to drive!!
But then I took 'er out for a high speed romp on the interstate finished off with a blast over a local mountain pass as I came pack home to my high mountain valley. Such a blast to drive!!
#2038
Heel & Toe
Member Since: May 2011
Location: Orlando Florida
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Breaking in new ring and pinion (just going lite on the throttle for a couple of weeks - don't have a clue if necessary, but figure won't hurt) and just ordered LMC5. (Column lock already disabled but messages annoying)
#2039
Safety Car
Member Since: Sep 2007
Location: Sunniest city on Earth
Posts: 4,169
Likes: 0
Received 21 Likes
on
20 Posts
Did you do the figure eights in a parking lot as suggested by GM after a fluid change?
#2040
Advanced
Member Since: Aug 2013
Location: Swindon Wiltshire
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Changed the relays in the passenger dcm. Looked at a few posts on here, and it saved me a bundle on shipping used dcm's that May or not work over the pond.
Couple of hours and job done, the door now locks/unlocks again.
Couple of hours and job done, the door now locks/unlocks again.