[Z06] What did you do to your Z06 TODAY??
#2945
Drifting
It look good to me.
Mark
Mark
#2946
Advanced
Member Since: Feb 2014
Location: Norwood North Carolina
Posts: 77
Received 0 Likes
on
0 Posts
Finally hut 500 miles on the clutch job. I have feel back in love with these cars! Drivabilty is great and I love the tick mastercyclinder. It falls into 3rd.
#2949
Finally installed the hurst shifter i picked up a couple of months back, replaced the ignition switch, changed the plugs/wires, and swapped the red top for a yellow top.
I should have done plugs/wires when I bought the car; it's riding like a completely different animal.
I should have done plugs/wires when I bought the car; it's riding like a completely different animal.
#2951
Heel & Toe
Member Since: Oct 2015
Location: Colorado Springs Colorado
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Had the motor out to do the clutch along with the trans to swap to an rpm and found these bonus parts in the oil pan. Now debating forged rods and pistons, heads are definitely going to AI for porting. Pretty sure the parts are valve stem seals and valve seat.
#2955
Race Director
Had to slam on the brakes at tripple speeds to avoid someone who moved into my lane without a turn signal and I flat spotted a rear tire. Time for new tires. Thinking about the NTO5's.
#2956
Racer
I like those. Luckily you were able to avoid an accident. Good luck on the tire search. Ebay has deals from time to time.
#2957
Instructor
It wasn't exactly today, but...
I have a garage with room for 3 cars, but is fitted with 2-10' doors. for the last several weeks in preparation for winter I rearranged the mess to find room to store my Z for the season. Still need to get a battery tender and roll it up on some carpet pieces. I have a cover but there are a few projects (mainly repairs) I want to do.
I used those hydraulic wheel dollies to move it into place. Worked very well; did it by myself.
I used those hydraulic wheel dollies to move it into place. Worked very well; did it by myself.
#2958
I ordered a bunch of new parts for my Z
Corvette Envy Modified tails
Hinson Engine and trans mounts
H3r Fire Extinguisher
Brey Krause Bracket
Kooks full 3 inch axle back (takes 5 weeks to make FYI) ordered about 2 weeks ago....
Now the waiting game for parts to come in so I can start installing. It is going to be a good new year!
Corvette Envy Modified tails
Hinson Engine and trans mounts
H3r Fire Extinguisher
Brey Krause Bracket
Kooks full 3 inch axle back (takes 5 weeks to make FYI) ordered about 2 weeks ago....
Now the waiting game for parts to come in so I can start installing. It is going to be a good new year!
#2959
i love my NT05's I have ran them on every fun car I have owned. I have a great website that has killer deals. obviously can't post the link her but if you want you can PM me and I will send it over.
#2960
Race Director