Notices
C5 General General C5 Corvette and C5 Z06 Discussion not covered in Tech
Sponsored by:
Sponsored by:

[Z06] opening trunk lid?

Thread Tools
 
Search this Thread
 
Old 03-03-2004, 05:18 PM
  #1  
1badvr4
Pro
Thread Starter
 
1badvr4's Avatar
 
Member Since: Aug 2003
Location: san antonio tx
Posts: 609
Likes: 0
Received 0 Likes on 0 Posts
Default opening trunk lid?

any of you guys have a problem opening the trunk lid when the doors are already shut? if i pop the trunk lid open, it barely goes up and i have to work my pinkie to try to open it. its really not a problem when i pop it with the door open, because when i shut the door the pressure from the cabin kinda poofs it up. any ideas, tricks, or advice?
Old 03-03-2004, 05:36 PM
  #2  
Jim 47
Melting Slicks
 
Jim 47's Avatar
 
Member Since: Jul 2000
Location: Wilmington DE
Posts: 2,483
Likes: 0
Received 1 Like on 1 Post

Default Re: opening trunk lid? (1badvr4)

Try a little graphite lubricant on the latck mechanism.

Jim
Old 03-03-2004, 05:38 PM
  #3  
Z_OH_6
Racer
 
Z_OH_6's Avatar
 
Member Since: Nov 2003
Posts: 487
Likes: 0
Received 0 Likes on 0 Posts
Default Re: opening trunk lid? (Jim 47)

Try a little graphite lubricant on the latch mechanism.

Jim
:iagree:
It should come up more than that. I'm betting some lube will do the trick. :yesnod:
Old 03-03-2004, 06:07 PM
  #4  
cactusZ06
Instructor
 
cactusZ06's Avatar
 
Member Since: May 2003
Location: San Francisco CA
Posts: 105
Likes: 0
Received 0 Likes on 0 Posts
Default Re: opening trunk lid? (1badvr4)

Try doing a search through the archives. This is a common and well documented problem, with an array of varying solutions. As Jim 47 suggested, additional lubricant on the latch mechanism seems to do the trick for most folks...myself included.
Old 03-03-2004, 11:44 PM
  #5  
jimvette
Instructor
 
jimvette's Avatar
 
Member Since: Nov 2000
Location: Denton Texas
Posts: 168
Likes: 0
Received 0 Likes on 0 Posts
Default Re: opening trunk lid? (1badvr4)

WD 40 worked for me.
Old 03-04-2004, 03:14 AM
  #6  
PowerMad
Pro
 
PowerMad's Avatar
 
Member Since: May 2002
Location: Meadows Place Texas
Posts: 552
Received 0 Likes on 0 Posts

Default Re: opening trunk lid? (1badvr4)

This seems to be a common issue for Z06 owners. I have never seen a Z06 that popped its trunk more than a few degrees, leaving very little "finger room" for lifting the lid. Even though I would prefer to have the deck lid pop up several inches instead of "just a tad", the small amount of lift provides enough room to squeeze my fingers in and lift the deck. Therefore, I rate it as a pretty minor issue and just live with it.

Even so, I suspect that the forum archives may contain many suggestions for service actions or modifications that will increase the gap created when the deck is opened.

dave
Old 03-04-2004, 11:45 PM
  #7  
Tonys torch
Instructor
 
Tonys torch's Avatar
 
Member Since: Jan 2004
Posts: 220
Likes: 0
Received 0 Likes on 0 Posts
Default Re: opening trunk lid? (PowerMad)

On this subject of trunk lids opening, its weird my 2002 Z06 only popped open just enough for my finger tips to get ahold of.

Now my new 2004 Z16 Z opens GREAT! it pops open about 2 to 3 inches just like it should. This car also seems more air tight and the seats are more comfortable. I see alot of improvements just from the 02 to the 04. Also my 02 Z only had 3600 miles on it before i traded in, so you cant say it was getting old.. lol..

Please let us know what you did to solve the problem
Old 03-05-2004, 12:54 AM
  #8  
lager99
Team Owner
 
lager99's Avatar
 
Member Since: Jul 2003
Location: [Enter Unoffensive Comment Here]
Posts: 34,299
Likes: 0
Received 1 Like on 1 Post
Cruise-In VI Veteran
Cruise-In VII Veteran
St. Jude Donor '06

Default Re: opening trunk lid? (1badvr4)

This has been posted before. Someone suggested you use your key to pry it up :lol: but I think the WD or graphite sounds better. :cheers:
Old 03-05-2004, 01:12 AM
  #9  
TooManyIDs
Safety Car
Support Corvetteforum!
 
TooManyIDs's Avatar
 
Member Since: Dec 1999
Location: Plano TX
Posts: 4,202
Received 2 Likes on 2 Posts

Default Re: opening trunk lid? (cactusZ06)

Try doing a search through the archives. This is a common and well documented problem, with an array of varying solutions. As Jim 47 suggested, additional lubricant on the latch mechanism seems to do the trick for most folks...myself included.
:iagree:
Old 03-05-2004, 10:53 AM
  #10  
RJTaylor
Intermediate
 
RJTaylor's Avatar
 
Member Since: Jan 2004
Location: LA
Posts: 28
Likes: 0
Received 0 Likes on 0 Posts

Default Re: opening trunk lid? (TooManyIDs)

Try doing a search through the archives. This is a common and well documented problem, with an array of varying solutions. As Jim 47 suggested, additional lubricant on the latch mechanism seems to do the trick for most folks...myself included.

:iagree:
:iagree:
Old 03-05-2004, 10:59 AM
  #11  
TexasRedZ06
Drifting
 
TexasRedZ06's Avatar
 
Member Since: Sep 2002
Location: Houston Texas
Posts: 1,407
Likes: 0
Received 0 Likes on 0 Posts
Default Re: opening trunk lid? (RJTaylor)

Seems like its a problem in the colder months. My Z only has 1 strut, so I do know there is a TSB out for adding the 2nd one. GM replaces the hinge and adds the 2nd gas strut.

If mine doesn't pop all the way, I just open a door and shut it. The air pressure pops up the trunk. I'm not in the trunk that much to bother with the GM repair.

Get notified of new replies

To opening trunk lid?




Quick Reply: [Z06] opening trunk lid?



All times are GMT -4. The time now is 11:02 AM.