C6 Seat Problems - Corvette Forum

Go Back   >
Log In 
Register FAQ Search Today's Posts Mark Forums Read Vendor Directory

C6 Corvette General Discussion
General C6 Corvette Discussion not covered in Tech Sponsored by
PFYC

C6 Seat Problems

Reply
 
 
 
Thread Tools Search this Thread
Old 04-05-2012, 05:24 PM   #1
ryanparmstrong
Junior Member
Thread Starter
 
Member Since: Nov 2011
Posts: 25
Thanks: 0
Thanked 0 Times in 0 Posts
Default C6 Seat Problems

Howdy forum members,

Just graduated Texas A&M and bought my first vette (2005 Blacked out 3LT with an LS3 swap).

I am fixing a couple of minor issues on the vehicle and am down to the drivers side seat. The memory module works, heating system works, and the lumbar system is functioning properly. However, it seems that the power seat adjuster isn't working.

All the fuses seem to be fine, so at this point all it can be is the seat motor or the seat controller module? or at least that is my best guess.

Any tips or thoughts?
ryanparmstrong is offline   Reply With Quote
Old 04-05-2012, 05:59 PM   #2
ChevyDave
CF Senior Member
Support Corvetteforum!
 
ChevyDave's Avatar
 
Member Since: Feb 2012
Location: skiatook oklahoma
Posts: 1,784
Thanks: 0
Thanked 22 Times in 20 Posts
Default

Dang, same problem as this?

http://forums.corvetteforum.com/c6-c...t-problem.html
ChevyDave is offline   Reply With Quote
Old 04-05-2012, 06:15 PM   #3
VET4LES
CF Senior Member
 
VET4LES's Avatar
 
Member Since: Oct 2004
Location: San Clemente CA
Posts: 27,401
Thanks: 0
Thanked 13 Times in 12 Posts
Default

Some C6's have connector problems. I know I did. The first thing you need to do is check the connectors under the seat. The picture below shows mine that I zip tied together. I pulled the tie very tight. This could solve your problem.

VET4LES is offline   Reply With Quote
Old 04-05-2012, 07:53 PM   #4
ryanparmstrong
Junior Member
Thread Starter
 
Member Since: Nov 2011
Posts: 25
Thanks: 0
Thanked 0 Times in 0 Posts
Default

I verified that the fuse is good and it is. Unfortunately my buddy is borrowing my socket set so I can't take the seat out till the weekend.

Does anyone know what kind of voltage levels that 6 pin connector puts out? Id guess 5V or 12V, but if anyone knows for sure that would be great! I am going to try and send the motor some voltage and see if it moves the seat to verify that its the controller and not the motor.

Thanks ChevyDave and VET4LES for the info!
ryanparmstrong is offline   Reply With Quote
Old 04-05-2012, 07:59 PM   #5
VET4LES
CF Senior Member
 
VET4LES's Avatar
 
Member Since: Oct 2004
Location: San Clemente CA
Posts: 27,401
Thanks: 0
Thanked 13 Times in 12 Posts
Default

I didn't take my seat out. I moved it back and up. I know you can't move it but try sticking your hand under it and pulling the wires out. If you can't do that try using a yard stick or something similar and move them around. That might be enough to get it to move.
VET4LES is offline   Reply With Quote
Old 04-05-2012, 09:00 PM   #6
ryanparmstrong
Junior Member
Thread Starter
 
Member Since: Nov 2011
Posts: 25
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Well, its the controller I'm almost 100% sure. The connector on the switch wasn't plugged in, and after I plugged it in and tried to start the car it seemed to short the car to ground and now my battery is dead. Its been a wonderful day.
ryanparmstrong is offline   Reply With Quote
Old 04-06-2012, 12:15 AM   #7
All2Easy
CF Senior Member
 
All2Easy's Avatar
 
Member Since: Mar 2012
Location: Missouri City Texas
Posts: 410
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Congrats on the car, and good luck with getting her sorted out!

Gig Em!

Thomas, class of '93
All2Easy is offline   Reply With Quote
Old 04-07-2012, 10:01 PM   #8
ryanparmstrong
Junior Member
Thread Starter
 
Member Since: Nov 2011
Posts: 25
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Thanks All2Easy! It's been a rough road, but luckily Im decent at troubleshooting this stuff. Guess that engineering degree paid off

Gig em!
ryanparmstrong is offline   Reply With Quote
Go Back   Corvette Forum >
Reload this Page
  • C6 Seat Problems
  •  
     
    Reply

    Related Topics
    Thread Thread Starter Forum Replies Last Post
    Seat Memory Module midlifetoy1 C6 Corvette General Discussion 1 11-03-2014 06:22 PM
    Seat belt light questions. Audio Alarm Module 1985 DanielRicany C4 Tech/Performance 9 01-11-2014 02:42 AM
    HELP???A6-SCM (Seat Control Module) B0856 H??? C5-1 C5 General 4 05-13-2013 02:38 PM
    Carvaggio seats - pass occupant sensor 2 GTOs C6 Z06 Discussion 11 01-11-2012 06:48 PM
    200.00 seat control module or .50 fuse??? PugLover C5 Tech 4 09-22-2007 04:25 AM


    Tags
    2005, c6, corvette, power, problems, seat

    Thread Tools Search this Thread
    Search this Thread:

    Click for Advanced Search

    Posting Rules
    You may not post new threads
    You may not post replies
    You may not post attachments
    You may not edit your posts

    BB code is On
    Smilies are On
    [IMG] code is On
    HTML code is Off
    Trackbacks are Off
    Pingbacks are Off
    Refbacks are Off

    Forum Jump


    All times are GMT -4. The time now is 02:38 AM.