Snake, I can't recall if it was di-noc or 1080, but I'm certain it was 3M. I just happened to have a sign shop near work that also did partial wraps on police/gov't cars & had a big piece of it on hand for $30.
If you do this with the matte black you'll be surprised how durable it is, & how well it matches all the other matte black stock trim. Couple pointers; be sure to leave enough material inside of the cut-outs, corners especially (vent ports, radio hole, etc) so that you can pull it tight enough so that it adheres completely & doesn't release at all.
Lastly, heat & pull the material tightly around/over the holes, for the shifter & drink holder especially, to prevent it from getting air tiny bubbles under it. Otherwise it's pretty straightforward to install this stuff & it's easy to pull the console & re-do certain spots if they're not perfect.
Last edited by Bedouin; 08-14-2012 at 12:37 PM.