Fog light hardware?
03-27-2013, 09:21 PM
#1
Advanced
Thread Starter
Member Since: Nov 2008
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Fog light hardware?
I repainted my corvette this past fall and seem to have lost or misplaced my hardware for my fog lights and at this point don't even know its size or what it looks like. Anybody help...
03-27-2013, 10:24 PM
#2
Supporting Vendor
Member Since: Sep 2007
Location: Pensacola Florida GO GATORS!!! www.rlsebring.com www.c6c7vette.com
Posts: 11,216
Received 174 Likes
on
92 Posts
St. Jude Donor '17
As far as screws to mount it they are the same as your fender screws. You'll need 3 for each side.
03-28-2013, 11:54 AM
#4
Supporting Vendor
Member Since: Sep 2007
Location: Pensacola Florida GO GATORS!!! www.rlsebring.com www.c6c7vette.com
Posts: 11,216
Received 174 Likes
on
92 Posts
St. Jude Donor '17
Yep. The fog light housing has a bracket that fits into the bumper and the screws hold it in place.
Do a search in the General section on Fog Lights. There should be some pics available.
Do a search in the General section on Fog Lights. There should be some pics available.
03-29-2013, 10:19 AM
#6
Tech Contributor
I have my bumper off right now. I will have some photos of the screw needed in a few minutes. It is smaller than the most used 7 mm screws and a slightly different thread.
