C6 Corvette General Discussion General C6 Corvette Discussion not covered in Tech
Sponsored by:
Sponsored by:

Completed my Magnaflow Install

Thread Tools
 
Search this Thread
 
Old 07-14-2013, 07:36 PM
  #1  
hawkandersonjr
Burning Brakes
Thread Starter
 
hawkandersonjr's Avatar
 
Member Since: Oct 2010
Location: US-ARMY 1974-1996 Retired ; Oklahoma, City ; Atlanta, Ga: Hephzibah, Ga
Posts: 926
Received 101 Likes on 37 Posts

Default Completed my Magnaflow Install

Finally installed my Magnaflows from the axle back that I bought from a forum member. Started about 10:30 AM Saturday and finished up about 2:30 PM. Could have save myself some headache and time if I had watch the install video found on the forum. I couldn’t get the passenger side out. Found out from the video you have to bend the tab on the heat shield on the gas tank on the passenger side. It dropped right out after that. The drive back from Augusta to Atlanta, Ga. on Sunday was great with no drone. Couldn’t open it up fully because of the rain, but managed to get her up in the 80 ish and it sounded great. This is a before and after sound bit.

BEFORE:

AFTER:


Last edited by hawkandersonjr; 07-14-2013 at 07:44 PM.
Old 07-14-2013, 07:39 PM
  #2  
peter pan
Life Time NCM #2196

Support Corvetteforum!
 
peter pan's Avatar
 
Member Since: Sep 2004
Location: Converse TX
Posts: 81,768
Received 1,099 Likes on 810 Posts

Default

Very nice
Old 07-14-2013, 07:47 PM
  #3  
raspyc6
Le Mans Master
 
raspyc6's Avatar
 
Member Since: Oct 2012
Location: Tampa Florida
Posts: 5,087
Received 35 Likes on 30 Posts

Default

sweet

Get notified of new replies

To Completed my Magnaflow Install




Quick Reply: Completed my Magnaflow Install



All times are GMT -4. The time now is 09:15 AM.