Mysterious C6 z06 front bumper mount point
#1
Mysterious C6 z06 front bumper mount point
So the first time I removed my front bumper to add a zr1 lip, I used the below guide to install my front splitter with no problems.
http://forums.corvetteforum.com/c6-z...ll-how-to.html
Since then, my car has been to a body shop for a repaint. I noticed that my front bumper did not sit straight across the bottom and had a upward tilt in the middle of the splitter. While removing the front bumper I notice 2 new mounts that the body shop had used that I didnt not notice the first time I added the zr1 lip. I went back to the guide but did not see it mentioned in the write up.
Does anyone who recently removed their front bumper have this bolt on their car? I circled the bolt in red
http://forums.corvetteforum.com/c6-z...ll-how-to.html
Since then, my car has been to a body shop for a repaint. I noticed that my front bumper did not sit straight across the bottom and had a upward tilt in the middle of the splitter. While removing the front bumper I notice 2 new mounts that the body shop had used that I didnt not notice the first time I added the zr1 lip. I went back to the guide but did not see it mentioned in the write up.
Does anyone who recently removed their front bumper have this bolt on their car? I circled the bolt in red
#2
Safety Car
They are definitely factory bits, but I recall some people having to forgo them in order to get an intercooler to fit like you have, since the rad support is normally lowered.