El Puto

I received my Northern Tool cross beam adapter from Northern Tool and this:

http://www.northerntool.com/webapp/w...6598_200326598

The woman assured me it would work with the cross beam adapter - it does not puta

And I can't find a jack that works with the cross beam adapter without some stupid modification necessary that I don't want to deal with

I'm about ready to just say f' it and put a 2x4 on the plate.

Where can I get a jack that works with the cross beam adapter without modification.?

rustyguns

2x4 works good! thats what i use

El Puto

Thanx - I saw a pic of someone doing it like that and it looked fine.

gimme5

http://www.z06vette.com/diy_lift.php

El Puto

Thanx - nice write up.

jpcortese

The cross beam works great without modification on my 3 ton Sears Craftsman jack. I need to get the car up a little before using this jack in the rear, but I also have a racing jack for that purpose. Using the racing jack, I jack up each side with the pucks, slide 2 2X6's under each wheel, then use the racing jack in the front with a 24" 2X4 and the Sears jack with the cross beam in the back.

allanlaw

I used the same kind of wood pieces for my C5, with the addition of small stop pieces on the board so that it would fit in the same place each time under the frame (and be centered on the jack table).

El Puto

Ahhhhhh - thank you!

RoHo

Me to, I have used a 2x6 for years on my C5Z and also on my new Z for both the front and back. There cheap and work great.

El Puto

Thanx! - I wanted to hear from someone who did it on a new Z without problems.