[ZR1] Wheel Spacers
#2
Instructor
#3
I was thinking that wheel spacers could bring the stock rims further out to the edge of the fender for a nicer look much like the aftermarket wheels so wasn't sure if anyone has done this with good results or bad results
#5
to order , if you had any issues , or before & after pics how it looked thanks
#6
Sorry I forgot to check this.
I did 3/4 on all 4 but I am thinking of going to .5" in the front with arp studs. I am a bit worried about tossing rocks into the doors and quarters in corners.
Front studs are easy to swap to longer ARP and just get hubcentric 1/2" spacers. Heres a chart.
I might sell off 1 pair of my 3/4's from the fronts and replace with .5 with arp studs. Ill post a photo when I get back to my other computer.
I did 3/4 on all 4 but I am thinking of going to .5" in the front with arp studs. I am a bit worried about tossing rocks into the doors and quarters in corners.
Front studs are easy to swap to longer ARP and just get hubcentric 1/2" spacers. Heres a chart.
I might sell off 1 pair of my 3/4's from the fronts and replace with .5 with arp studs. Ill post a photo when I get back to my other computer.
The following users liked this post:
TripleBlackZ06 (03-23-2017)
#8
Interesting topic.
I never thought of doing this on the ZR1...I would love to see before and after pictures as well.
I did spacers on my 2016 Alfa 4C and my 2001 911 Turbo. They look incredible !
I never thought of doing this on the ZR1...I would love to see before and after pictures as well.
I did spacers on my 2016 Alfa 4C and my 2001 911 Turbo. They look incredible !
#9
Here is an after from before it was wrapped up for winter. I dont have much that shows specifically the wheel offset.
#11
Drifting
Is there any concern about using wheel spacers & putting the studs in a double shear scenario for failure? It's not like you hear about it often, just wondering.
#13