Fs/ft 03 cobra for c6 z06
#1
Instructor
Thread Starter
Fs/ft 03 cobra for c6 z06
http://s1050.photobucket.com/user/magee630/library/
Hopefully the link worked. And I realize this is a Ford on a Corvette forum but everyone who shows interest everywhere else ends up disappearing, conveniently. With intentions of selling this to get a C6Z i figured I may as well try the source itself!
Its an 03 Redfire Cobra coupe with just over 16k miles. mods are as follows: with less than 1k miles
Polished 2.8H KB w/3.1 pulley
Accufab throttle body
80lb Ford Injectors
Steeda CAI
Division X fuel rails
Killer Chiller 2nd gen
BBK Longtube headers, BBK O/R xpipe into Mac exhaust
Spec 3 900HP rated clutch
26spline input shaft
Mcleod TOB
custom driveshaft with chromoly yokes
recently installed MGW orange handle shifter with custom Redfire SVT shift ****
Maximum motorsports subframe connectors only been on the car a month.
Eibach pro kit lowering springs
stock 3.55 gears
Billet Flow Diff brace
IRS with FTBR bushing kit installed this past February
Glenns Performance sump tank
Holley performance external fuel pump
(Fuel system was pieced together and installed by Adam Maurer at S&M Motorsports in Cleves OH, as well as all performance installations)
Also tuned by Adam and made 621/610 on his Mustang Dyno
car runs on E85 and is an absolute beast!!
Installed 18" XXR 531 Platinum rims in June, 9.5 in front and 11" in rear with 335/30/18 Hoosier DR(rear wheel well lip is NOT shaved/rolled)
Paint is 9.5 outta 10 with a couple typical rock chips in the front you have to look for to even see.
Thats all i can remember for now, anything i missed please let me know.
Clean and clear title so no loan to be payed off.
ASKING $29K OBO!!!
Looking to trade for C6 Z06 with money on my end of course, prefer basic bolt ons with less than 50K miles. Any color but Yellow.
Email me at adamagee630@yahoo.com for further questions
Hopefully the link worked. And I realize this is a Ford on a Corvette forum but everyone who shows interest everywhere else ends up disappearing, conveniently. With intentions of selling this to get a C6Z i figured I may as well try the source itself!
Its an 03 Redfire Cobra coupe with just over 16k miles. mods are as follows: with less than 1k miles
Polished 2.8H KB w/3.1 pulley
Accufab throttle body
80lb Ford Injectors
Steeda CAI
Division X fuel rails
Killer Chiller 2nd gen
BBK Longtube headers, BBK O/R xpipe into Mac exhaust
Spec 3 900HP rated clutch
26spline input shaft
Mcleod TOB
custom driveshaft with chromoly yokes
recently installed MGW orange handle shifter with custom Redfire SVT shift ****
Maximum motorsports subframe connectors only been on the car a month.
Eibach pro kit lowering springs
stock 3.55 gears
Billet Flow Diff brace
IRS with FTBR bushing kit installed this past February
Glenns Performance sump tank
Holley performance external fuel pump
(Fuel system was pieced together and installed by Adam Maurer at S&M Motorsports in Cleves OH, as well as all performance installations)
Also tuned by Adam and made 621/610 on his Mustang Dyno
car runs on E85 and is an absolute beast!!
Installed 18" XXR 531 Platinum rims in June, 9.5 in front and 11" in rear with 335/30/18 Hoosier DR(rear wheel well lip is NOT shaved/rolled)
Paint is 9.5 outta 10 with a couple typical rock chips in the front you have to look for to even see.
Thats all i can remember for now, anything i missed please let me know.
Clean and clear title so no loan to be payed off.
ASKING $29K OBO!!!
Looking to trade for C6 Z06 with money on my end of course, prefer basic bolt ons with less than 50K miles. Any color but Yellow.
Email me at adamagee630@yahoo.com for further questions
#12
Instructor
Thread Starter