Need a schematic for Alkycontrol setup
#1
Safety Car
Thread Starter
Member Since: Aug 2006
Location: Apache Junction AZ
Posts: 4,347
Likes: 0
Received 22 Likes
on
18 Posts
Need a schematic for Alkycontrol setup
I need to be able to figure out where to connect the the Orange wire labeled "Injection percentage input". Basically, I think I need to tap into the ramp voltage output of the progressive controller.
BJK
BJK
#2
Team Owner
If you have the alkycontrol kit why not download the alkycontrol instructions that have all of that? You posted AEM instructions. Which kit do you have?
ECS's website has the alky control instructions with diagrams.
http://www.eastcoastsupercharging.co...pac-wiring.pdf
ECS's website has the alky control instructions with diagrams.
http://www.eastcoastsupercharging.co...pac-wiring.pdf
Last edited by Unreal; 09-22-2012 at 03:17 PM.
#3
Safety Car
Thread Starter
Member Since: Aug 2006
Location: Apache Junction AZ
Posts: 4,347
Likes: 0
Received 22 Likes
on
18 Posts
I have been on the ECS site, last night actually, and didn't see the info. I'll give it another shot. So far the only thing I have been able to find was a very poor copy of minimal install info for a C5.
BJK
#4
Team Owner
Well contact AEM. I don't know of anyone with one of those kits. Alkycontrol is by far the best kit so good luck with the AEM.
#6
Le Mans Master
if I get this right you are installing the AEM failsafe kit on an Alky Control meth kit? If you get it to work please let us know. Julio would be the guy to ask.