8 Second Street car C6Z (Video)
#82
Any update Fran for this and the other F2 build,,, hope if you can share the track results
#83
Le Mans Master
Thread Starter
Bone stock besides a Pfadt rear drag bar.
Ran it with the F1r but since we had to run a 5 inch pulley to keep boost around 22 psi it slowed the blower down big time low and mid range. Only went 8.6@163 with a 1.4 60... We are putting a 4.63 pulley on it and a waste gate to control boost up top... Should have results ina couple weeks... Its torn apart right now.
F2 car no track results yet..
Ran it with the F1r but since we had to run a 5 inch pulley to keep boost around 22 psi it slowed the blower down big time low and mid range. Only went 8.6@163 with a 1.4 60... We are putting a 4.63 pulley on it and a waste gate to control boost up top... Should have results ina couple weeks... Its torn apart right now.
F2 car no track results yet..
#84
Bone stock besides a Pfadt rear drag bar.
Ran it with the F1r but since we had to run a 5 inch pulley to keep boost around 22 psi it slowed the blower down big time low and mid range. Only went 8.6@163 with a 1.4 60... We are putting a 4.63 pulley on it and a waste gate to control boost up top... Should have results ina couple weeks... Its torn apart right now.
F2 car no track results yet..
Ran it with the F1r but since we had to run a 5 inch pulley to keep boost around 22 psi it slowed the blower down big time low and mid range. Only went 8.6@163 with a 1.4 60... We are putting a 4.63 pulley on it and a waste gate to control boost up top... Should have results ina couple weeks... Its torn apart right now.
F2 car no track results yet..
I'm sure this will be one of the fastest procharged vettes,,,good luck Fran with both cars...
#85
Le Mans Master
Thread Starter
#86
#87
Le Mans Master
Thread Starter
#88
Melting Slicks
Fran, little off topic but for those 18x12 did you have to modify the brake duct because of rubbing or did yours clear ok? Put em on my GS with 345 35 18 et streets and they seem perfect just a little close to that duct and was wondering if yours were a direct bolt on or what... Thanks'
#89
#90
Le Mans Master
Thread Starter
Just Kidding haha... Procharger for life
We put a smaller pulley on this car with the F1X and are adding a 60mm Precision waste gate along with an AMS 500V2 boost controller
We put a smaller pulley on this car with the F1X and are adding a 60mm Precision waste gate along with an AMS 500V2 boost controller
#92
Le Mans Master
Thread Starter
#93
#94
Le Mans Master
Thread Starter