GTPSS

I want some nice like this manifolds for the fender kit...

staticki

I am interested in the 6182R setup. Any actual customers on this kit that have provided dyno numbers?

You mentioned that the kit comes standard with the coating now. Can you send me a quote for the kit plus ID2000 injectors?

WICKEDFRC

How many days down time does it take to install this kit at your location? And, does this TT Kit for a C6 Z06 cause any issues with emissions? (Sorry if I don't know much about turbos).

0CK@UPPCOS

Generally it takes ~week to install, and a couple days for tuning. However if you're a traveling customer (from another state) we like to allot for more time so we have more than ample test time before we release you onto the road with it, just to make sure everything is tight and right.

And no, this kit is not exactly "emissions friendly". It does remove the cats as part of the install process, however you could use aftermarket high-flow cats down stream which may make you emissions friendly again, depending on your area and what all the regulations are.

CK

ProEFI

can you explain to me how hard is to change plugs with that kit?!

Ultrasport05

Been covered already. Apparently it's easier that you'd think. Go up from the bottom

staticki

CK

Any pics of how the plug wires are mounted or how the power steering reservoir is relocated?

0CK@UPPCOS

You can see the PS reservoir right in the front here, and the plug wires protruding from under the coil heat shield in the front. 2x from the front, and the rear two go from the rear.


CK

SpeedRite

Any updates on drivability and heat with new coating?

TheTinMan

sub'd

Arctic Vette

Wow thats scary close to headers...

0CK@UPPCOS

Everything seems to be good with the heat coating, it really dropped the under-hood temps.

The manifolds are pretty close to alot of things, but that's why we've taken such lengths with the heat coating and shielding to protect everything that's vulnerable.

CK

Arctic Vette

Any vids or other installed pics/dynos etc?

0CK@UPPCOS

The only one that we've done was the one R&D vehicle here in house. I think I may have some dyno vid that I haven't uploaded yet, I'll have to check. All the rest that we've sold have been shipped out, many overseas to the middle east. Hopefully we should start seeing some video from them showing up on youtube here soon.


CK

Arctic Vette

Would be nice for more vids n pics..

Flyr282

sub'd. Ive been curious if there was one of these kits out there.

0CK@UPPCOS

Yes, there's quite a few out there. Not too sure how many are on the boards here though.

CK

TheTinMan

Any way to route the wastegate dump into the downpipe?

Shadd

Is there an install video like you guys made for the fender mount system? Also, is there a pdf of the install manual?
Sorry if this has been addressed previously.

0CK@UPPCOS

It may be possible, but because of the limited room and extreme complexity, we opted away from that option.