ARH 2" to 2 1/8" headers with 3.5" Hpipe, Vband connections, "Getting it done"
#22
Switched from my old kooks to this great ARH headers!
Tight install but fits perfectly nice with slight little cut of frame on driver side and also I need to check on starter side as it is touching the wrap on my starter...
Huge headers and great quality thanks ARH
Tight install but fits perfectly nice with slight little cut of frame on driver side and also I need to check on starter side as it is touching the wrap on my starter...
Huge headers and great quality thanks ARH
#23
Premium Supporting Vendor
Thread Starter
Nice pic!!
#24
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes
on
1,052 Posts
St. Jude Donor '15
Those look goood.
#25
Burning Brakes
What kind of modifications are needed? Is it just bending the filet out of the way or is it more structural? Do you have any pics of these modifications? I'm in the market for a new set of headers since I'm living in the past still running my ARH 1 7/8" x 3".
#27
Supporting Vendor
The set we have for Ace32x's ZR1 is super impressive!! I no joke lol'd when I saw them, they are so "bulgy"
__________________
Cordes Performance Racing aka "CPR"
Owner of AZ's premier LSX/LTX motorsports shop
http://cordesperformanceracing.com/
www.facebook.com/cordesperformanceracing.com
joe@cordesperformanceracing.com
480-359-5914
Cordes Performance Racing aka "CPR"
Owner of AZ's premier LSX/LTX motorsports shop
http://cordesperformanceracing.com/
www.facebook.com/cordesperformanceracing.com
joe@cordesperformanceracing.com
480-359-5914
#31
Premium Supporting Vendor
Thread Starter
We have a few sets headed down to Texas and Louisiana shortly.
Must be a big event coming up in March.
http://tx2k.com/
Must be a big event coming up in March.
http://tx2k.com/
#34
Melting Slicks
im interested to see how much they make on an f1x car over my 2" .. i know when we tried to buy 2 1/8" we were told "buy at your won risk.. might not fit" so stuck to 2".. and then bham a few weeks later .. 2 1/8" released
#35
Premium Supporting Vendor
Thread Starter
These monsters have been installed on a few cars now.
Last edited by SteveDoten@ARH; 02-27-2015 at 07:22 PM.
#36
Melting Slicks
#38
Melting Slicks