Dudeman v2.0
09-08-2016, 09:24 AM
#181
Drifting
Thread Starter
09-08-2016, 09:27 AM
#182
09-08-2016, 09:30 AM
#183
Drifting
Thread Starter
09-22-2016, 02:26 PM
#186
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes
on
1,052 Posts
St. Jude Donor '15
I like the white
09-22-2016, 04:22 PM
#191
Drifting
Thread Starter
Debating still if Im going to relocate it(I will need new lines, extend at least 10 wires, etc). Bleeding would work the same as it does stock if I keep the module/abs. I might just delete it go manual brakes though. Still up in the air.
09-22-2016, 08:09 PM
#192
Green gets my vote. Green is mean!
10-05-2016, 08:21 PM
#194
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes
on
1,052 Posts
St. Jude Donor '15
Woohoo. Done next week?
10-06-2016, 08:20 PM
#196
Damn that's a lot of welding! 
Good looking welds though.
Now, wouldn't it have been easier if you just used some of that 4"" stainless steel flex pipe that they use on dump trucks and ****??
Good looking welds though.
Now, wouldn't it have been easier if you just used some of that 4"" stainless steel flex pipe that they use on dump trucks and ****??
10-07-2016, 03:42 PM
#197
Drifting
Thread Starter
Intake manifold just got powder coated today
10-07-2016, 04:53 PM
#198
Nice!
Now you just gotta fab up one of those 5 gallon hoods scoops from the Middle East to cover that!
Now you just gotta fab up one of those 5 gallon hoods scoops from the Middle East to cover that!
10-07-2016, 06:36 PM
#199
Drifting
Thread Starter
