APS TT install
#1
APS TT install
Hi all
I am in the middle of doing an installation of an aps system. The kit came with a magnavolt bap and I don't have the instructions for this, the manual only shows install for the msd bap. If any of you have the wiring diagram or could tell me what goes where please help. I am booked for a dyno tune at the end of the week and a bit concerned I may not make it..Thanks in advance.
I am in the middle of doing an installation of an aps system. The kit came with a magnavolt bap and I don't have the instructions for this, the manual only shows install for the msd bap. If any of you have the wiring diagram or could tell me what goes where please help. I am booked for a dyno tune at the end of the week and a bit concerned I may not make it..Thanks in advance.
#2
Burning Brakes
Member Since: Mar 2007
Location: Wichita Falls, TX
Posts: 1,118
Likes: 0
Received 9 Likes
on
7 Posts
Not familiar with the magnavolt bap, post a couple of pictures so I can see what you have. I used the kenne bell bap for my APS TT install and mine came with four wires, one ground, one red wire with fuse that hooks in to the fuel pump harness, the other end to another red wire off the BAP. The fourth wire which should be the longest, running to the front into a hobbs switch to a boost source.