C6 Forced Induction/Nitrous C6 Corvette Turbochargers, Superchargers, Pulley Upgrades, Intercoolers, Wet and Dry Nitrous Injection, Meth
Sponsored by:
Sponsored by:

Highest HP stock bottom LS2

Thread Tools
 
Search this Thread
 
Old 11-16-2016, 01:17 PM
  #41  
Vade46
Instructor
Support Corvetteforum!
Thread Starter
 
Vade46's Avatar
 
Member Since: Mar 2009
Location: Long Island NY
Posts: 192
Received 6 Likes on 6 Posts

Default

Originally Posted by curtisb23
A stick car on a radial the 1.64 isn't all that bad ,are you expecting the mph to go up any?
I used to cut consistent high 1.4's-low 1.5's but that was with half as much HP. I only made 4 passes that day and was dropping my times on each run but since it was so hot I didn't want to beat on the car too much. The track conditions were really terrible that day so I'd hope the MPH goes up a little bit.

Last edited by Vade46; 11-16-2016 at 01:20 PM.
Old 11-16-2016, 01:24 PM
  #42  
curtisb23
Drifting
 
curtisb23's Avatar
 
Member Since: Sep 2014
Posts: 1,742
Received 30 Likes on 30 Posts
Default

Originally Posted by Vade46
I used to cut consistent high 1.4's-low 1.5's but that was with half as much HP. I only made 4 passes that day and was dropping my times on each run but since it was so hot I didn't want to beat on the car too much. The track conditions were really terrible that day so I'd hope the MPH goes up a little bit.
I'd u cut 2 tenths off the 60 that's like 2 tens on et .just curious because I have a smaller blower and I'm not sure on hp and I'm running right there with you
Old 11-16-2016, 05:22 PM
  #43  
Gxpz06
Safety Car
 
Gxpz06's Avatar
 
Member Since: Aug 2013
Posts: 3,962
Received 64 Likes on 54 Posts

Default

Originally Posted by curtisb23
I'd u cut 2 tenths off the 60 that's like 2 tens on et .just curious because I have a smaller blower and I'm not sure on hp and I'm running right there with you
2 tenths on 60 is more like 4 tenths at the eighth which depends on car could be as much as 5-6 tenths lower et at 1320 feet
Old 11-16-2016, 05:24 PM
  #44  
curtisb23
Drifting
 
curtisb23's Avatar
 
Member Since: Sep 2014
Posts: 1,742
Received 30 Likes on 30 Posts
Default

Originally Posted by Gxpz06
2 tenths on 60 is more like 4 tenths at the eighth which depends on car could be as much as 5-6 tenths lower et at 1320 feet
Yeah I ment to say 3 tenths ,but it's hard to tell really. My car 1/8 miles you'd never think it would mph what it does out the back .just bench racing is all it is
Old 11-16-2016, 05:27 PM
  #45  
Gxpz06
Safety Car
 
Gxpz06's Avatar
 
Member Since: Aug 2013
Posts: 3,962
Received 64 Likes on 54 Posts

Default

Originally Posted by curtisb23
Yeah I ment to say 3 tenths ,but it's hard to tell really. My car 1/8 miles you'd never think it would mph what it does out the back .just bench racing is all it is
you mean your car picks up 30ish mph on back half ?
Old 11-16-2016, 05:31 PM
  #46  
curtisb23
Drifting
 
curtisb23's Avatar
 
Member Since: Sep 2014
Posts: 1,742
Received 30 Likes on 30 Posts
Default

Originally Posted by Gxpz06
you mean your car picks up 30ish mph on back half ?
35 actually
Old 11-16-2016, 05:46 PM
  #47  
Gxpz06
Safety Car
 
Gxpz06's Avatar
 
Member Since: Aug 2013
Posts: 3,962
Received 64 Likes on 54 Posts

Default

Originally Posted by curtisb23
35 actually
WOW big power or lightweight? guessing MN12 gearing ?

I have my 2nd spot available for this fridays forum rental at MIR if anyone wants it
The following users liked this post:
maustin195 (11-18-2016)
Old 11-16-2016, 05:49 PM
  #48  
curtisb23
Drifting
 
curtisb23's Avatar
 
Member Since: Sep 2014
Posts: 1,742
Received 30 Likes on 30 Posts
Default

Originally Posted by Gxpz06
WOW big power or lightweight? guessing MN12 gearing ?

I have my 2nd spot available for this fridays forum rental at MIR if anyone wants it
Full weight street car .06 ls2 tr6060 z51 with 342 gear .I saw two spots opened up wish I could make it I'm not to far from mir .
Old 11-18-2016, 03:54 PM
  #49  
Vade46
Instructor
Support Corvetteforum!
Thread Starter
 
Vade46's Avatar
 
Member Since: Mar 2009
Location: Long Island NY
Posts: 192
Received 6 Likes on 6 Posts

Default

I picked up 33.53mph on the back half of that pass


Last edited by Vade46; 11-18-2016 at 03:54 PM.
Old 12-02-2016, 10:58 PM
  #50  
Vade46
Instructor
Support Corvetteforum!
Thread Starter
 
Vade46's Avatar
 
Member Since: Mar 2009
Location: Long Island NY
Posts: 192
Received 6 Likes on 6 Posts

Default

Still need more track time to get my 60fts sorted out but I got a new best today and my MPH really shows how much power this thing is making. Picked up 38.34mph on the back half.
Went 10.03 @149.93 with a shitty 1.67 60ft Sucks that I'll have to wait until next year to get in a good pass....damn winter.

Last edited by Vade46; 12-02-2016 at 11:00 PM.
Old 12-03-2016, 10:34 AM
  #51  
ZincGT
Racer
 
ZincGT's Avatar
 
Member Since: Jul 2014
Location: Denver Colorado
Posts: 253
Received 28 Likes on 22 Posts
Default

22 pounds from a 2200r made 1021, turned the timing down to 13* made 830, best pass was 10.57 but I was on the brakes at the 1000 foot trapped 125 in the 1/4 107 in the 1/8 with no launch on that pass. Broke an axle trying to launch next pass.
Old 12-03-2016, 11:29 AM
  #52  
Frans96ss
Le Mans Master
 
Frans96ss's Avatar
 
Member Since: Jul 2005
Location: New Castle Del.
Posts: 7,405
Received 352 Likes on 210 Posts
St. Jude Donor '09

Default

Originally Posted by Vade46
Still need more track time to get my 60fts sorted out but I got a new best today and my MPH really shows how much power this thing is making. Picked up 38.34mph on the back half.
Went 10.03 @149.93 with a shitty 1.67 60ft Sucks that I'll have to wait until next year to get in a good pass....damn winter.
Wow. 150 is rippin
Old 12-03-2016, 03:11 PM
  #53  
schpenxel
Race Director
 
schpenxel's Avatar
 
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes on 1,052 Posts
St. Jude Donor '15

Default

Originally Posted by ZincGT
22 pounds from a 2200r made 1021, turned the timing down to 13* made 830, best pass was 10.57 but I was on the brakes at the 1000 foot trapped 125 in the 1/4 107 in the 1/8 with no launch on that pass. Broke an axle trying to launch next pass.
What mods? And what fuel?
Old 12-03-2016, 03:15 PM
  #54  
ZincGT
Racer
 
ZincGT's Avatar
 
Member Since: Jul 2014
Location: Denver Colorado
Posts: 253
Received 28 Likes on 22 Posts
Default

Originally Posted by schpenxel
What mods? And what fuel?
228/232 cam, longtubes, e85 and the blower
Old 12-03-2016, 03:17 PM
  #55  
schpenxel
Race Director
 
schpenxel's Avatar
 
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes on 1,052 Posts
St. Jude Donor '15

Default

That's awesome. E85 ftw
Old 12-03-2016, 03:20 PM
  #56  
ZincGT
Racer
 
ZincGT's Avatar
 
Member Since: Jul 2014
Location: Denver Colorado
Posts: 253
Received 28 Likes on 22 Posts
Default

Originally Posted by schpenxel
That's awesome. E85 ftw
I had no intention of going that high lol, that's why I turned it down also in fear of the SBE. New shortblock is under way so I can turn it back up
Old 12-15-2016, 01:22 PM
  #57  
westtexasbuff
Instructor
 
westtexasbuff's Avatar
 
Member Since: Jun 2008
Location: Austin Texas
Posts: 238
Received 16 Likes on 10 Posts

Default

I made 870whp on my 150k mile stock bottom end on 15lbs. Could have made more but called it a day. I'm happy with it.

Stock heads/intake
China studs
Ls9 head gaskets
Btr stage 3 turbo cam
E85
Billet s476



Quick Reply: Highest HP stock bottom LS2



All times are GMT -4. The time now is 04:54 PM.