RWHP Expectations
#1
Intermediate
Thread Starter
RWHP Expectations
2006 Base Model Ls-2 30K miles A6 Transmission
mods
lingenfelter cai
LG Motorsports Longtube super pro headers (cat less)
corsa extreme exhaust
aa Vortech v3-si trim blower
alkycontroller meth system 50/50 mix ?
cam (mild not purchased yet) thinking btr 220/230 range from aa titanium retainers ?
what kind of RWHP will I be looking at with a moderate tune ? Should I be concerned about my differential or half shafts ? Thanks in advance and sorry if my post is vague or lacking needed details. I am new to all this.
Jude
mods
lingenfelter cai
LG Motorsports Longtube super pro headers (cat less)
corsa extreme exhaust
aa Vortech v3-si trim blower
alkycontroller meth system 50/50 mix ?
cam (mild not purchased yet) thinking btr 220/230 range from aa titanium retainers ?
what kind of RWHP will I be looking at with a moderate tune ? Should I be concerned about my differential or half shafts ? Thanks in advance and sorry if my post is vague or lacking needed details. I am new to all this.
Jude
#2
Drifting
I'm not qualified to answer, but I'll take a wild *guess*...you didn't mention pulley size or boost. 93 octane?
I'd guess ~570 rwhp.
No on the parts listed, A6 might be the area of concern (proper tune is important here)
Most will likely suggest 100% meth.
Replace the harmonic balancer while apart
Consider creating a build thread and asking for input.
My opinion, worth what you paid for it...
I'd guess ~570 rwhp.
No on the parts listed, A6 might be the area of concern (proper tune is important here)
Most will likely suggest 100% meth.
Replace the harmonic balancer while apart
Consider creating a build thread and asking for input.
My opinion, worth what you paid for it...
Last edited by Chiselchst; 09-25-2016 at 08:41 AM.
The following users liked this post:
junkboyjude (09-25-2016)
#3
Around 600 whp with a cam, good tune, and 100% meth. There's no need to dump washer fluid into your motor. 100% meth is so cheap and has so many benefits. The one thing I would suggest is a trans cooler. The extra power really heats up these transmissions.
#4
Intermediate
Thread Starter
Okay. Thanks a lot. I will do that. I think I saw a place on the AA Corvette thread to do a build page. I will look back over it. Thanks a million. I will have to check on the pulley size but I do know the guys at the garage mentioned ordering a different harmonic balancer.
#5
Safety Car
Okay. Thanks a lot. I will do that. I think I saw a place on the AA Corvette thread to do a build page. I will look back over it. Thanks a million. I will have to check on the pulley size but I do know the guys at the garage mentioned ordering a different harmonic balancer.
Last edited by irok; 09-25-2016 at 03:31 PM.
The following users liked this post:
junkboyjude (09-25-2016)