FS: Livernois CNC Ported Stage 3 Heads
#1
Burning Brakes
Thread Starter
FS: Livernois CNC Ported Stage 3 Heads
SOLD
Livernois
CNC Ported Stage 3 GM LS-Series Cylinder Heads
Seasoned GM LS2 castings
5 axis CNC machined
Fully assembled
220cc Intake Runner
Stainless 2.020 Intake Valves
Stainless 1.575 Exhaust Valves
GM valve seals
Super 7 locks
Livernois dual coil valve springs good to ~ .690 lift
Livernois titanium retainers
Lift Intake Exhaust
.200 151.5 114.5
.300 211.4 150.1
.400 265.5 180.4
.500 197.2 190.6
.600 307.6 205.8
310.9 210.4
http://www.livernoismotorsports.com/...t.phtml?p=1352
In various tests performed by gmhighperformance.com, the Livernois Stage 3 CNC Ported heads outflow was over 30cfm more than SLP L92’s at .600 lift on intake and 15cfm more on exhaust…
The heads have been milled .030 which bumps the compression up by about .5:1 which still allowed me to run street gas while also picking up some seat of the pants torque and hp.
They have about 30,000 miles on them.
$1,300 Shipped
Livernois
CNC Ported Stage 3 GM LS-Series Cylinder Heads
Seasoned GM LS2 castings
5 axis CNC machined
Fully assembled
220cc Intake Runner
Stainless 2.020 Intake Valves
Stainless 1.575 Exhaust Valves
GM valve seals
Super 7 locks
Livernois dual coil valve springs good to ~ .690 lift
Livernois titanium retainers
Lift Intake Exhaust
.200 151.5 114.5
.300 211.4 150.1
.400 265.5 180.4
.500 197.2 190.6
.600 307.6 205.8
310.9 210.4
http://www.livernoismotorsports.com/...t.phtml?p=1352
In various tests performed by gmhighperformance.com, the Livernois Stage 3 CNC Ported heads outflow was over 30cfm more than SLP L92’s at .600 lift on intake and 15cfm more on exhaust…
The heads have been milled .030 which bumps the compression up by about .5:1 which still allowed me to run street gas while also picking up some seat of the pants torque and hp.
They have about 30,000 miles on them.
$1,300 Shipped
Last edited by Isaiah48; 11-29-2010 at 07:34 AM.