Northern Tool 2-ton Cross Beam Adapter for Floor Jack $19.99
#1
Drifting
Thread Starter
Northern Tool 2-ton Cross Beam Adapter for Floor Jack $19.99
If you have a Northern Tool anywhere near you and you have been wanting one of these like I have, call them and see if they have one in stock. They were $49.99 but have been discontinued. I stopped by the local store and happened to find one in stock and they are now clearance priced at $19.99
Item Number 154883
It's no longer on their website, but perhaps you might get lucky and find one at your local Northern Tool store.
Best of luck, hope this helps to find you one!
Here's what they look like:
http://shop.ebay.com/i.html?_nkw=cro....c0.m270.l1313
Here are some of the Corvette Forum write-ups:
http://forums.corvetteforum.com/guid...m-Adapter.html
.
Item Number 154883
It's no longer on their website, but perhaps you might get lucky and find one at your local Northern Tool store.
Best of luck, hope this helps to find you one!
Here's what they look like:
http://shop.ebay.com/i.html?_nkw=cro....c0.m270.l1313
Here are some of the Corvette Forum write-ups:
http://forums.corvetteforum.com/guid...m-Adapter.html
.
Last edited by Silverado Desperado; 05-26-2011 at 11:16 PM.
#3
Safety Car
Member Since: Aug 2006
Location: Apache Junction AZ
Posts: 4,347
Likes: 0
Received 22 Likes
on
18 Posts
To work properly on a vet these need to be cut down. I cut 3" off each end of the black frame and 2.75 off each of the sliding arms. I also had the centering pin remover and tuned down to 1" to fit my jack and then welded back in.
BJK
BJK
Last edited by 07MontRedcp; 05-27-2011 at 12:26 PM.