dumthusk

Hey I purchased a set of the old switch backs from another company which I had to buy resistors due to hyper flash and had a bad experience cause resistor got hot and touch my wiring harness and melted it....do u need resistors for these new bulbs?

0corvettemods1

you need to use resistors anytime you swap a halogen bulb with a LED bulb. With proper install, the resistors don't cause any issues. The resistors only get hot during blinker operation as well.

crAzy

About to purchase but want some questions answered before.
Getting these switchback leds with resistors will eliminate all yellow from my DRLs?

Also if I purchase resistors can you guys put them together before shipping out so I can just remove and install mt DRLs without doing any other modifications?

Now if these make the DRLs white all times the only time yellow comes on is when the blinker is on?

0corvettemods1

Yes, the bulbs will eliminate that amber color for you.

The resistors have to be installed on your cars harness. Don't worry they just snap on!

crAzy

can you send me instructions on where to plug in the resistors and how to install the drl light bulbs?

0corvettemods1

Sure, pm us your email address

Nino S

just when I thought I had all of my lights done with corvette mods HID and LED kits you guys come out with something else for me to buy!!!! Great seller and I have had nothing but great results with all of your products and placing my order for these tonight after work!!

0corvettemods1

ILikeMyZ06

You mentioned that these will be amber during normal driving without the headlights on... Is there a way to make them white during normal driving and flash amber only during blinker operation?

Thanks!

0corvettemods1

no, that option isn't currently available.

Ryan5508

I just installed my switchback. Driver Side works fine but passanger side is still hyper flashing even with the resistor. Any ideas? bad resistor?

Ryan5508

I solved it on after playing with it for a while.

the quick-connect tabs were not cutting through to the wires. I removed them trimmed the wire back a bit and reinstalled everything. Now its working fine.

zdonner

Would you mind sending me a quote for the following;

Switch back + Resistors + (stock color) HID Fogs + Reverse Lights

and

Switch back + Resistors + (stock color) HID Fogs + HID Highs (35 and 55w) + Reverse Lights.

and shipping to 30308.


Thanks!


-Zach

0corvettemods1

sent

Rayzzz

Could it be wired up so that the bulbs thought the headlights where on all the time. That would make the lights white then switch to amber like nite time.

0corvettemods1

You would have to bypass your stock wiring

ebf2k

I bought the all white DRLs but not sure where to mount the resistors?

0corvettemods1

In the instructions it states to mount them to the two outside wires of the harness.

ebf2k

I understood that part, but I don't know where to physically place the resistors so they get adequate cooling and don't melt anything.

0corvettemods1

You can call tech in the morning