FS: Custom Standalone Fuel cell for nitrous
#1
Le Mans Master
Thread Starter
Member Since: May 2011
Location: Tampa FL (formerly Justinjor)
Posts: 5,022
Likes: 0
Received 14 Likes
on
9 Posts
Tech Contributor
St. Jude Donor '11-'12-'13-'14
FS: Custom Standalone Fuel cell for nitrous
For sale is my barely used, custom made standalone fuel cell that was professionally fabricated and powdercoated.
It has an Aeromotive fuel pressure regulator, fuel pressure gauge, and fuel pressure safety switch. It also has a Walbro 255lph fuel pump with a very short amount of run time as I only put a couple bottles through the car with the standalone in place. I finally got the fuel cell made and ended up breaking the rear end in the car which forced a change of heart on vehicle platform.
The cell also features a handy fuel pump cradle for ease of changing if you ever need to swap it out.
The fuel cell mounts in place of the battery and utilizes the OEM battery tie down for ease of installation. It also features banana clip wiring connectors.
Here are some pictures and a video of it in action.
$650 shipped!
Paypal ok but please add 3% or send as gift. Also, I only ship to a verified address in the lower 48 states.
Thanks for looking!
It has an Aeromotive fuel pressure regulator, fuel pressure gauge, and fuel pressure safety switch. It also has a Walbro 255lph fuel pump with a very short amount of run time as I only put a couple bottles through the car with the standalone in place. I finally got the fuel cell made and ended up breaking the rear end in the car which forced a change of heart on vehicle platform.
The cell also features a handy fuel pump cradle for ease of changing if you ever need to swap it out.
The fuel cell mounts in place of the battery and utilizes the OEM battery tie down for ease of installation. It also features banana clip wiring connectors.
Here are some pictures and a video of it in action.
$650 shipped!
Paypal ok but please add 3% or send as gift. Also, I only ship to a verified address in the lower 48 states.
Thanks for looking!
Last edited by JUIC3D; 03-19-2013 at 02:14 PM.
#7
Le Mans Master
Thread Starter
Member Since: May 2011
Location: Tampa FL (formerly Justinjor)
Posts: 5,022
Likes: 0
Received 14 Likes
on
9 Posts
Tech Contributor
St. Jude Donor '11-'12-'13-'14
Looking to sell this today. No reasonable offer refused. Someone needs this gorgeous piece in their engine bay.