[Z06] My Active Handling problem fixed
04-21-2012, 08:09 PM
#21
Instructor
Member Since: Feb 2006
Location: Waterfall, PA
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
I had this problem in an 06 Convertible. I went through the connector fixes, wiring replacement and everything else the dealer wanted to try. After two lane departures, I'd had enough.
Ultimately, it was the brake control module. It was a problem with this module communicating with the other modules. It was captured with a data collection box that the dealer installed. You'll only get the basic codes without this data collection box. I posted the blow by blow a long time ago.
Ultimately, it was the brake control module. It was a problem with this module communicating with the other modules. It was captured with a data collection box that the dealer installed. You'll only get the basic codes without this data collection box. I posted the blow by blow a long time ago.
The following users liked this post:
corrado (08-12-2016)
08-14-2016, 12:41 PM
#24
Melting Slicks
Recall:
http://nhthqnwws112.odi.nhtsa.dot.go...056-31583P.pdf
:: LINK to DIY procedure, click here.
SUGGESTION: When performing a DIY, visit dealer in order to record and/or substantiate the fix as well as clear any relative/outstanding codes.
http://nhthqnwws112.odi.nhtsa.dot.go...056-31583P.pdf
:: LINK to DIY procedure, click here.
SUGGESTION: When performing a DIY, visit dealer in order to record and/or substantiate the fix as well as clear any relative/outstanding codes.
