[Z06] Comp Cam Rocker bearing upgrade kit
01-16-2013, 10:39 PM
#1
Instructor
Thread Starter
Comp Cam Rocker bearing upgrade kit
Hi all,
Couple of questions for those who have installed the kit.....
1. Diameter slop of the needle bearings on the trunion shaft seems excessive. I measure it at about 0.030. If there is that mush slop that could change geometry. Do your kits exhibit excessive slop?
2. I haven't installed yet so I can see the race decreasing in diameter slightly but not 0.030, has anybody measured the ID of the race diameter installed with the needles?
THX
B
Couple of questions for those who have installed the kit.....
1. Diameter slop of the needle bearings on the trunion shaft seems excessive. I measure it at about 0.030. If there is that mush slop that could change geometry. Do your kits exhibit excessive slop?
2. I haven't installed yet so I can see the race decreasing in diameter slightly but not 0.030, has anybody measured the ID of the race diameter installed with the needles?
THX
B
