[Z06] Pulling The Trigger, Here We Go....My Build
#46
Melting Slicks
Thread Starter
#48
Supporting Vendor
This has been a great build folks and we're expecting some good numbers out of this one. We even made some improvements such as running a direct "hotwire" 10 gauge power wire to the boost a pump on a relay so we're not pulling high amps through the stock harness. The ECS kit deletes the power steering cooler so we're most likely going to fab something up and add in a few new AN lines with a separate cooler. We have been sending pics daily to keep the OP up to speed on the build.
#52
Melting Slicks
Thread Starter
Updated Post 2!
We will be tuning soon enough....now starting to think about the other things -
Decisions Decisions - which wheel/tire setup do I go with? Both HRE's. 540s (polished lips/brushed centers) with MPSS or c21's (matte black with polished hardware; lighter that 540s) with Nt05r..... I may be wrapping the car matte white :secret:
We will be tuning soon enough....now starting to think about the other things -
Decisions Decisions - which wheel/tire setup do I go with? Both HRE's. 540s (polished lips/brushed centers) with MPSS or c21's (matte black with polished hardware; lighter that 540s) with Nt05r..... I may be wrapping the car matte white :secret:
#56
Melting Slicks
Thread Starter
#57
Melting Slicks
Thread Starter
Sorry I have been busy!
New pictures added to post 2
Well, we blew out the clutch on the dyno (I know, you guys told me so!), needed to swap out the pulley (had the ls3 for some reason), restrictor plate (was 2.75" instead of 2.5"), and relocate the IAT sensor. I hope we will be tuning soon enough...
New pictures added to post 2
Well, we blew out the clutch on the dyno (I know, you guys told me so!), needed to swap out the pulley (had the ls3 for some reason), restrictor plate (was 2.75" instead of 2.5"), and relocate the IAT sensor. I hope we will be tuning soon enough...
Last edited by Geared; 04-24-2015 at 10:26 PM.
#60
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,194 Likes
on
1,053 Posts
St. Jude Donor '15
Nice build! You're spending some money, but it sure looks nice!
I had the same concern/issue with the ECS kit. Missing a few small things, and that hose was the wrong size. I mean, it works.. but not so awesome. I bought an adapter too but haven't put it on yet.
The directions they provide would be more useful in the bathroom than in helping put the kit on the car, but anyways.. sub'd for results!
I had the same concern/issue with the ECS kit. Missing a few small things, and that hose was the wrong size. I mean, it works.. but not so awesome. I bought an adapter too but haven't put it on yet.
The directions they provide would be more useful in the bathroom than in helping put the kit on the car, but anyways.. sub'd for results!