[Z06] Ported FAST 102 - Pictures and Results
#1
Drifting
Thread Starter
Ported FAST 102 - Pictures and Results
Over the past few weeks I've pulled my car down for a few mods including reaching out to a fellow forum member who specializes in porting of LS products.
I've seen quite a bit of the work from said forum member and decided to give him a shot after checking out some heads he recently completed on his YouTube channel.
Throughout the whole process he kept me up to date on receipt, starting of work, pictures during, and the final product after. I have not taken the car back to the dyno yet to see what the gains were, however I hope to do so this weekend. I have to finish my Nitrous Outlet standalone fuel system them I'm going to let her eat.
A considerable amount of work was put into the manifold and I'm happy. I can tell you that the butt dyno feels a nice gain down low. I gently went WOT and had to back out of it up top due to the need for more fuel.
Check out the pictures below and let me know your thoughts:
I'll save the next post for before and after dyno plot overlays.
I've seen quite a bit of the work from said forum member and decided to give him a shot after checking out some heads he recently completed on his YouTube channel.
Throughout the whole process he kept me up to date on receipt, starting of work, pictures during, and the final product after. I have not taken the car back to the dyno yet to see what the gains were, however I hope to do so this weekend. I have to finish my Nitrous Outlet standalone fuel system them I'm going to let her eat.
A considerable amount of work was put into the manifold and I'm happy. I can tell you that the butt dyno feels a nice gain down low. I gently went WOT and had to back out of it up top due to the need for more fuel.
Check out the pictures below and let me know your thoughts:
I'll save the next post for before and after dyno plot overlays.