[Z06] Z06 fender badge placement, is there a factory alignment hole in the carbon fender???
#1
Premium Supporting Vendor
Thread Starter
Z06 fender badge placement, is there a factory alignment hole in the carbon fender???
Do all 06-13 OEM Carbon Z06 fenders have the alignment hole for the badge?
I'm not referring to the Carbon 2011 editions, as all 8 years of the Z06 had Carbon material front fenders.
Thanks very much for any help.
I'm not referring to the Carbon 2011 editions, as all 8 years of the Z06 had Carbon material front fenders.
Thanks very much for any help.
#3
Premium Supporting Vendor
Thread Starter
No kidding, maybe it was only the 2006 that had the alignment hole.
Worth noting, if the badges are chrome like yours the car is a 2009up or they have been replaced with the 2009up version
2006-2008 OEM were silver.
Worth noting, if the badges are chrome like yours the car is a 2009up or they have been replaced with the 2009up version
2006-2008 OEM were silver.
#4
Safety Car
Member Since: Dec 1999
Location: Virginia Beach, VA & Port Charlotte, FL (snowbird)
Posts: 4,407
Received 1,095 Likes
on
578 Posts
My car is a 07 w/o any holes.
BTW, my badges are custom made, billet aluminum, CNC cut and polished. (note the 640hp)
BTW, my badges are custom made, billet aluminum, CNC cut and polished. (note the 640hp)
Last edited by Undy; 12-01-2015 at 04:11 PM.
#7
Melting Slicks
I had holes in mine too... But I don't think it was there for badge alignment. Always thought it was for overseas models that required side markers
The following users liked this post:
SteveDoten@ARH (12-02-2015)
#10
Racer
fender Emblems
I have 2011 C6Z and had carbon fiber emblems made by a forum vendor and my fenders had no holes so I had to mark use painters tape. Work out perfectly, in my opinion.
Last edited by sdwncm; 12-02-2015 at 09:01 AM.
The following users liked this post:
SteveDoten@ARH (12-02-2015)