[Z06] Dyno numbers in
05-06-2016, 09:32 AM
#1
Burning Brakes
Thread Starter
Dyno numbers in
Finally got car done and tuned!
Blue is my car and red another car. I am running Hinson Headers and he is running American Racing headers.
Both cars running same cam, LG G7X4 and same headwork done. Not sure what exhaust he has. I have the LG GT2 exhaust.
This post is not comparing headers, just happen that my tuner overlaid them. He was expecting more HP from my car.
The headers were the only difference .
Blue is my car and red another car. I am running Hinson Headers and he is running American Racing headers.
Both cars running same cam, LG G7X4 and same headwork done. Not sure what exhaust he has. I have the LG GT2 exhaust.
This post is not comparing headers, just happen that my tuner overlaid them. He was expecting more HP from my car.
The headers were the only difference .
Last edited by Whis9; 05-06-2016 at 09:32 AM.
05-06-2016, 10:41 AM
#3
Burning Brakes
Thread Starter
One thing I need to add is he was having troubles with my knock sensors reading false knock and issue with clutch pedal going to floor at RPM's. By no means this 100% accurate graph. Just figured everyone would ask what the differences between the two graphs were
05-06-2016, 01:09 PM
#4
Melting Slicks
Header Sizes
I know the Hinson are 1 7/8 I presume so are the ARH tube sizes.
05-06-2016, 01:14 PM
#5
Burning Brakes
Knock sensor will pull timing, killing power.
Its not the headers, I run Hinson's on my combo and they support the power.
05-08-2016, 08:09 PM
#7
Burning Brakes
Thread Starter