Chicagoland auto body paint?
#1
Instructor
Thread Starter
Member Since: Nov 2014
Location: Mandeville Louisiana
Posts: 114
Likes: 0
Received 3 Likes
on
3 Posts
Chicagoland auto body paint?
I'm looking for a reputable painter in the Chicagoland area (I'm in the south burbs, here for work so I don't know the area well). I was debadging my beautiful car and well 😢 I went a little too hard with the eraser wheel on the rear bumper... 😢 thankfully I had already planned to paint the rear carbon flash, now I just need to find a reputable painter to do the job. Any help, any suggestions?
#2
I'm looking for a reputable painter in the Chicagoland area (I'm in the south burbs, here for work so I don't know the area well). I was debadging my beautiful car and well �� I went a little too hard with the eraser wheel on the rear bumper... �� thankfully I had already planned to paint the rear carbon flash, now I just need to find a reputable painter to do the job. Any help, any suggestions?
http://www.remesautobody.com/
Last edited by ArcticC7; 03-05-2015 at 08:29 PM.
#3
Yea, here ya go and they only use the factory water borne low voc paints. no one else touches my cars.
http://www.remesautobody.com/
http://www.remesautobody.com/
They do approve PPG products which the shop you referred uses. However there are better products than PPG Deltron.
Here is the 2015 GM approved products list if you have time to kill.
http://www.axaltacs.com/content/dam/...pproval-GM.pdf
Last edited by Satch0922; 03-05-2015 at 08:43 PM.
#4
What do you mean "factory" paint? GM does not make paint however they do use several paint manufacturers.
They do approve PPG products which the shop you referred uses. However there are better products than PPG Deltron.
Here is the 2015 GM approved products list if you have time to kill.
http://www.axaltacs.com/content/dam/...pproval-GM.pdf
They do approve PPG products which the shop you referred uses. However there are better products than PPG Deltron.
Here is the 2015 GM approved products list if you have time to kill.
http://www.axaltacs.com/content/dam/...pproval-GM.pdf
#5
#6
Racer
I'm looking for a reputable painter in the Chicagoland area (I'm in the south burbs, here for work so I don't know the area well). I was debadging my beautiful car and well 😢 I went a little too hard with the eraser wheel on the rear bumper... 😢 thankfully I had already planned to paint the rear carbon flash, now I just need to find a reputable painter to do the job. Any help, any suggestions?
.
#7
Make it Straight in Park Forest. Hands down best in the south side.
http://www.makeitstraightautobody.com/
http://www.makeitstraightautobody.com/
#8
Great but not cheap
I have always used Westmont Body Werks. They typically do work for high end cars like Mercedes, Lexus, Lambo, Bently, etc. Do fantastic work. Had some custom work on my C7 and it is better than new. Not cheap, but really good.
Here is their web site http://www1.wbodywerks.com
Phone630) 325-0545.
Here is their web site http://www1.wbodywerks.com
Phone630) 325-0545.