WingTech Z51 spoiler install
#1
Instructor
Thread Starter
WingTech Z51 spoiler install
I just picked up a Z51 type spoiler from Southern Car Parts that is made by WingTech. Unfortunately, it only has two screws (13 inches in from each side of the spoiler). Has anyone installed this particular spoiler, and if so, how did you mount it? With only two screws, I am guessing I am going to need to add some 3M tape for the other areas or make a template and add more screws, but wanted to get other's thoughts.
#2
Le Mans Master
Member Since: Jul 2015
Location: Northern California
Posts: 6,223
Received 1,694 Likes
on
1,240 Posts
St. Jude Donor '15
I've seen posts on here about people doing tape only installs of spoilers. Of course having it bolted would be the most secure, but I think it would be fine. If someone did have a problem though, I don't think they're rushing to the internet to talk about it.
#3
#5
Instructor
Thread Starter
It is not a wicker bill, but a Z51 type spoiler. Below is the link:
http://www.southerncarparts.com/corv...er-p-9203.html
I am not going to try to make it work, as I am going to return it and get the official GM part.
http://www.southerncarparts.com/corv...er-p-9203.html
I am not going to try to make it work, as I am going to return it and get the official GM part.