C7 Corvette American Racing Headers - Free Shipping
#41
Supercharged
Chip, I'm running 9 PSI on a 2015 C7 A&A supercharger. What size long tube headers should I go with? I assume the mids are out?
#44
Melting Slicks
I am curious about this too. You would think that if you can get the 15 HP gain just from a tune then the 20+ HP gains for the headers and a tune should get a total of 35+ HP?
#45
Premium Supporting Vendor
Thread Starter
Member Since: Oct 2004
Location: Manassas Park VA
Posts: 36,679
Received 421 Likes
on
322 Posts
St. Jude Donor '07-'08,-'13-'14, '16-'17
You WILL need a lift - Not a must, but I would not try it without one
for long tubes...
Here is a write up another member did on the shorties
https://www.corvetteforum.com/forums...th-headers.htm
The long and short of it is that it is not really a project for a weekend
warrior, however if you have a decent amount of experience working
on Corvettes, it can be done.
The last set I did at my house took about 12 hours, but we were
farting around and drinking some cold ones...
Regards
Chip
for long tubes...
Here is a write up another member did on the shorties
https://www.corvetteforum.com/forums...th-headers.htm
The long and short of it is that it is not really a project for a weekend
warrior, however if you have a decent amount of experience working
on Corvettes, it can be done.
The last set I did at my house took about 12 hours, but we were
farting around and drinking some cold ones...
Regards
Chip
The following users liked this post:
Mike Campbell (06-30-2016)