(ARH C7 Mid-Length) 26whp gains with no tuning, no CEL, easy install........
#44
Low End TQ
Any loss (or gain) of low end torque with these headers with cats?
#45
Pro
I have a small video of my car with the 1 7/8" American Racing LONG TUBE headers but I'm not sure if they sound anything remotely close to the mid length ones. I still have cats and my factory NPP exhaust if that helps..
#46
Premium Supporting Vendor
#47
#48
Premium Supporting Vendor
Thread Starter
Not a direct side by side comparison, but the LT's will make about 8-10whp more on an NA car.
https://www.corvetteforum.com/forums...-inside-2.html
https://www.corvetteforum.com/forums...-inside-2.html
#49
Do you supply gaskets with the headers? Oops, see on the ARH website gaskets included.
Last edited by marcouvo; 05-01-2015 at 01:37 AM. Reason: found the answer
#51
Racer
I don't recall the exact numbers, but they mirrored the gains in HP closely throughout the entire range.
It is available with and without cats, it is not legal in Calif, tuning may net more gains, part # is C7ML34WC
I'm sure we could do something and set you up with a local installer/dealer, Steve@americanracingheaders.com
Appreciate the feedback, that was the exact goal with this system
You won't have any worries about the CEL with the mids regardless of any Xpipe we have seen.
Thanks very much for the questions
It is available with and without cats, it is not legal in Calif, tuning may net more gains, part # is C7ML34WC
I'm sure we could do something and set you up with a local installer/dealer, Steve@americanracingheaders.com
Appreciate the feedback, that was the exact goal with this system
You won't have any worries about the CEL with the mids regardless of any Xpipe we have seen.
Thanks very much for the questions
Steve, does ARH make an x pipe, no cats for the C7 Z51, similar to Borla, but better flowing, lighter etc? If yes, cost please.
#53
Melting Slicks
I installed the catless mid lengths and they sound AMAZING. I didn't notice a huge power increase but then again 20hp would be hard to butt dyno on a 460 hp car.
I did get a CEL right away though, looks like the catless version will require a tune to eliminate the CEL..
I did get a CEL right away though, looks like the catless version will require a tune to eliminate the CEL..
#57
Instructor
Looking to add something to my Corsa off-road catless x-pipe. This might fit the bill.
Steve - can you recommend a dealer/installer in the NoVa/MD area? Forum vendor with a good price would be just as good I suppose.
Thanks!
Steve - can you recommend a dealer/installer in the NoVa/MD area? Forum vendor with a good price would be just as good I suppose.
Thanks!
The following users liked this post:
C7 x 2 (04-28-2016)
#59
Racer
Steve, I ordered a set on Monday through a vendor for my '16 Z06 which already has a Borla catless x-pipe and ATAK exhaust system. They are telling me you won't ship them until sometime next week. Anyway to get these moving sooner. I have a really big car show coming up on May 7 and would love to pull in with these on the car.
The following users liked this post:
SteveDoten@ARH (04-29-2016)
#60
Melting Slicks
The following users liked this post:
SteveDoten@ARH (04-29-2016)