MSD atomic airforce intake results
#1
Instructor
Thread Starter
MSD atomic airforce intake results
I just put a msd intake manifold on my car and we did before and after dyno runs to see exactly what we got from the intake.
Mods on car are:
Cai, e85, lt headers, cam, ported heads
We got 28 rwhp and 10rwtq
I will post the dyno sheet tomorrow when i get a chance.
Pretty impressed with what i picked up off just the intake.
Mods on car are:
Cai, e85, lt headers, cam, ported heads
We got 28 rwhp and 10rwtq
I will post the dyno sheet tomorrow when i get a chance.
Pretty impressed with what i picked up off just the intake.
#6
Racer
Good luck with your runs, let us know the results.
#7
Instructor
Thread Starter
Im hitting Benson tonight and Fayetteville Sunday.
Benson just reopened. Its
brand new now with heated track. Its pretty sweet. Wish it was a 1/4 mile track.
Benson just reopened. Its
brand new now with heated track. Its pretty sweet. Wish it was a 1/4 mile track.
#8
Race Director
Member Since: Jul 2007
Location: Texas Hill Country
Posts: 10,763
Received 2,379 Likes
on
1,238 Posts
what were the before and after numbers? 470 and 498?
#13
Instructor
#15
#17
Instructor
A recent dyno test shows 20 WHP and 21 WTQ gains on an otherwise stock '16 Camaro LT1 SS with gains throughout the powerband without tuning. The Camaro LT1 engine is a little different than the Stingray LT1 but the results are encouraging and its worth a try to me. Test is here: http://www.camaro6.com/forums/showthread.php?t=439890
Last edited by WarBaby; 04-16-2016 at 07:04 AM.
The following users liked this post:
kiley2418 (04-16-2016)
#18
Race Director
Member Since: Jul 2007
Location: Texas Hill Country
Posts: 10,763
Received 2,379 Likes
on
1,238 Posts
This intake is putting down pretty close to what I got out of a ported stock intake. Right around that 20-25 mark.
Last edited by Higgs Boson; 04-16-2016 at 07:31 AM.
#19
#20
Race Director
Member Since: Jul 2007
Location: Texas Hill Country
Posts: 10,763
Received 2,379 Likes
on
1,238 Posts
If I remember right, I put down 440rwhp with a ported manifold and throttle body only before I built the 416. I never dyno'd the 416 by itself but I think it was around 550-575 with a tiny cam and now has the ECS 1500 and need to dyno it still but if the lb/min are close then it should be in the 950 rwhp range.
The TB is WeaponX and the intake manifold might be a Formato.....I can't remember, it's been a while since I got those.
The TB is WeaponX and the intake manifold might be a Formato.....I can't remember, it's been a while since I got those.