HorsePowerAddicts C7Z A8 Baseline Dyno Video
#1
Former Vendor
Thread Starter
HorsePowerAddicts C7Z A8 Baseline Dyno Video
We picked up our shop 2015 A8 Z06 from Mike Furman at Criswell Chevrolet this morning at 9am. Mike had the car sitting out front and all paperwork ready. Only about a 30 minute process before we were back on the road which worked out perfect as we had cars getting picked up and dropped off at noon back at the shop. If anyone is looking to buy a Corvette give Mike@Criswell a call.
One to the baseline.... We drove straight back to our dyno and strapped the car down to our in ground Dynojet 224x. The car was still warm from the trip and layed down 555rwhp 600rwtq SAE corrected. In the cool air it was over 570rwhp uncorrected.
We are more than impressed with the A8 so far. We plan to push this car pretty far so stay tuned for updates.
One to the baseline.... We drove straight back to our dyno and strapped the car down to our in ground Dynojet 224x. The car was still warm from the trip and layed down 555rwhp 600rwtq SAE corrected. In the cool air it was over 570rwhp uncorrected.
We are more than impressed with the A8 so far. We plan to push this car pretty far so stay tuned for updates.
Last edited by HorsePowerAddicts; 03-28-2015 at 05:50 PM.
#5
Team Owner
#6
Former Vendor
Thread Starter
We have not dyno'd an M7 Z06. This car was at 150 miles while we did the baseline. The fuel was the original fuel Criswell filled it with. No timing was pulled during the dyno run. Our dynojet reads right on with all other dynojets SAE corrected.
#7
#8
Former Vendor
Thread Starter
We Just recently Did some bolt ons to the car.. Stay tuned for another video here soon!!
#9
Race Director