tcmc5

Sold

AZ FASTEST

Is it just the seat or does it have the rails, etc.? Was it in a C6? I'm concerned if it will fit. Thanks!

tcmc5

Only have the seat for sale. It should fit fine in the C6 unless it's narrower than the C5.

ghoffman

It will fit in a C6 or C6ZO6 with our rails perfectly.

forhamilton

Do you have a schematic that show the dimensions?

tcmc5

Here's Sparco's dimensional chart
http://www.sparcousa.com/resourceFiles/26.pdf

forhamilton

I really like the seat. My only concern is that I'm a big guy. The out to out dimensions of my shoulders are 23". Almost every race seat I try I find myself slouching and pulling my shoulders forward and in. I am assuming your shoulders fit into the seat at the top of the C dimension. I'm afraid my lats and shoulders won't fit in the seat. What is your out to out shoulder dimension and how do your shoulders fit?

tcmc5

I doubt the seat would fit you very well. I'm about 21" in the same dimension and if I were 2" wider I don't think I'd be too comfortable. Unfortunately, it's going to be difficult to install a seat wide enough. With my seat, there's little clearance from the shoulder bolster to the door.

Lancer033

If you've still got the seat in Dec/Jan let me know. I'm planning to put one in for a passenger seat, but with me moving back to the states soon, there's no point in shipping it over here just to ship it back, and I don't have anywhere to ship it in the states right now.

forhamilton

Thanks for checking. I think I am going to have to go with a Kirkey. If it is not wide enough, I can always tweak the seat because it is aluminum.

Dr Chill

Can I purchase the hardbar mounts from you with the seat?

tcmc5

Seat has been sold. Thanks.