Snitz track car/I need to towel off!
#1
Burning Brakes
Thread Starter
Member Since: Mar 2006
Location: Arlington Heights Illinois
Posts: 829
Likes: 0
Received 2 Likes
on
2 Posts
Snitz track car/I need to towel off!
We are getting pretty Fricken close! Shown below is the Motec wiring getting reconnected after paint
Now for the carbon fiber dash and Motec LCD.
Fire projection sys:
The sway bars we had fabricated. They are approx 2” in diameter. The wings on each side can be rotated 90 degrees to adjust the stiffness.
Rear wing being mounted
Now for the carbon fiber dash and Motec LCD.
Fire projection sys:
The sway bars we had fabricated. They are approx 2” in diameter. The wings on each side can be rotated 90 degrees to adjust the stiffness.
Rear wing being mounted
#2
Racer
Looking good Tom. Is it going to see the track before October 31st? If so, you need to contact me so that I can be present for the inaugural drive . . . .
Congrats!
Congrats!
#3
Le Mans Master
#4
Burning Brakes
Thread Starter
Member Since: Mar 2006
Location: Arlington Heights Illinois
Posts: 829
Likes: 0
Received 2 Likes
on
2 Posts
I'm raffling off inaugural first drive tickets. Mike has been pleading and begging however as he wants to be the first guy to take this baby sideways across the finish line!
But seriously folks, George is shooting to get this baby out of the bull pen for a drive next week! I'm on the edge of my seat!
But seriously folks, George is shooting to get this baby out of the bull pen for a drive next week! I'm on the edge of my seat!
#5
Premium Supporting Vendor
Looks like it will be done with time to spare for Track Attack 2009
#10
Burning Brakes
Thread Starter
Member Since: Mar 2006
Location: Arlington Heights Illinois
Posts: 829
Likes: 0
Received 2 Likes
on
2 Posts
http://www.acproducts.us/corvetteracebod.htm
#18
Burning Brakes
Thread Starter
Member Since: Mar 2006
Location: Arlington Heights Illinois
Posts: 829
Likes: 0
Received 2 Likes
on
2 Posts
ACP roof glued on yesterday. Roof Lexan front/rear windshields are installed. Wiring harness/elect rehook just about done. Front brake ducts installed so front bumper, splitter & undertray can get attached.